Ad
related to: how to install expansion anchors concrete
Search results
Results from the WOW.Com Content Network
Anchor bolts are used to connect structural and non-structural elements to concrete. [2] The connection can be made by a variety of different components: anchor bolts (also named fasteners), steel plates, or stiffeners. Anchor bolts transfer different types of load: tension forces and shear forces. [3]
The anchor selection, together with additional reinforcement, and rigging arrangements is influenced by: - The dead weight of the element - The number of anchors in the element and the configuration of the anchor - Capacity of the anchor at the specific concrete compressive strengths at time of lift - The dynamic loads applied during lifting ...
Figure 1 of the original patent for the molly bolt, U.S. Patent No. 2,018,251. The molly bolt was patented in 1934 by George Frederick Croessant. [3] Although his patent acknowledges that expandable fasteners of this general kind were already known, Croessant's patent is intended to provide "an improved and adequate anchoring grip that may be retightened if necessary and that will permit ...
Anchor channels, invented by Anders Jordahl in 1913, are steel channels cast flush in reinforced concrete elements to allow the installation of channel bolts for the fastening of components. Anchor channels consist of steel C-shaped channels and anchors (mostly headed studs ) which are connected to the channel by welding or riveting/forging.
The wooden expansion joint compresses as the concrete expands. ... to prevent and minimize expansion joint failure. During installation, ... deterioration of anchors ...
A pipe anchor is a rigid support that restricts movement in all three orthogonal directions and all three rotational directions, i.e. restricting al the 6 degrees of freedom This usually is a welded stanchion that is welded or bolted to steel or concrete. [2] In case of anchor which is bolted to concrete, a special type of bolt is required ...
The screw itself should be drilled a minimum of 1" into the concrete to hold effectively and a maximum of 1-3/4" or the threads will wear and will lose holding power. Ideally 1-1/4" to 1-1/2" of screw thread in the concrete. [1] So for example, if a 1/2" board is being screwed onto the concrete, a 1-3/4" to 2" concrete screw should be used ...
Grouted tiebacks can be constructed as steel rods drilled through a concrete wall out into the soil or bedrock on the other side. Grout is then pumped under pressure into the tieback anchor holes to increase soil resistance and thereby prevent tiebacks from pulling out, reducing the risk for wall destabilization.
Ad
related to: how to install expansion anchors concrete