enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Split beam nut - Wikipedia

   en.wikipedia.org/wiki/Split_beam_nut

   A split beam nut, also known as a split hex nut [1] or slotted beam nut, [2] is a locknut with slots cut in the top that separate the outside end into two [3] or more sections that are bent slightly inward, making the thread diameter undersized in the slotted portion.

3. Distorted thread locknut - Wikipedia

   en.wikipedia.org/wiki/Distorted_thread_locknut

   A distorted thread locknut, [1] is a type of locknut that uses a deformed section of thread to keep the nut from loosening due to vibrations, or rotation of the clamped item. . There are four types: elliptical offset nuts, centerlock nuts, toplock nuts and partially depitched (Philidas) nu

4. Split nut - Wikipedia

   en.wikipedia.org/wiki/Split_nut

   A split nut is a nut that is split lengthwise into two pieces (opposed halves) so that its female thread may be opened and closed over the male thread of a bolt or leadscrew. [1] This allows the nut, when open, to move along the screw without the screw turning (or, vice versa, to allow the screw to pass through the nut without turning).

5. Nut (hardware) - Wikipedia

   en.wikipedia.org/wiki/Nut_(hardware)

   Barrel nut, barrel bolt, binding barrel, Chicago screw, post and screw or connector bolt Has a barrel-shaped flange and protruding boss that is internally threaded Split nut: Split lengthwise into two pieces (opposed halves) so that its female thread may be opened and closed over the male thread of a bolt or leadscrew Sleeve nut: Spring nut

6. Hillman Solutions - Wikipedia

   en.wikipedia.org/wiki/Hillman_Solutions

   Solidifying its focal shift from industrial to retail customers in 1999, Sunsource financed its Axxess key cutting acquisitions (see below) by selling off two fastener units, Kar Products and A&H Bolt and Nut Company, to Glencoe Capital, [5] which sold them on to Barnes Group in 2003.

7. Castellated nut - Wikipedia

   en.wikipedia.org/wiki/Castellated_nut

   Slotted nuts do not have this rounded modification. The flat sides of slotted nuts extend fully from the top to the bottom of the nut. Both castellated and slotted nuts are designed to use a pin (usually a split pin) that fits through the slots and through a hole in the screw to which the nut is attached. This pin prevents the nut from turning ...

8. Split pin - Wikipedia

   en.wikipedia.org/wiki/Split_pin

   A split pin (UK usage) / cotter pin (UK/USA usage) holding a rod in place with a washer. A split pin, also known as a cotter pin, or cotter key in the US, [1] is a metal fastener with two tines that are bent during installation, similar to a staple or rivet.

9. Insert nut - Wikipedia

   en.wikipedia.org/wiki/Insert_nut

   The screw-in insert nuts come in various sizes and take different screw sizes. For example, an M6 insert nut will take an M6 bolt, a "1/4-20" insert nut will take a 1/4-20 inch bolt., etc The pre-drilled hole must be as deep as the length of the insert nut plus any portion of the bolt that may be screwed past the end of the nut in the work piece.