Search results
Results from the WOW.Com Content Network
Although the most common medium format film, the 120 roll, is 6 cm (2.4 in) wide, and is most commonly shot square, the most common "medium-format" digital sensor sizes are approximately 48 mm × 36 mm (1.9 in × 1.4 in), which is roughly twice the size of a full-frame DSLR sensor format.
A few rockets and some fit-in-the-box aircraft are made to this size. 1:120: 0.1 in: 2.54 mm: Model railways (TT) Derived from the scale of 1 inch equals 10 feet.TT model railroad scale. Used in AD&D Battlesystem Skirmishes rules. Works with 15 mm miniatures where a 6 foot man would equal 15.24 mm 1:110: 2.771 mm
So a 1 / 2 in (12.7 mm) diameter drill will be able to drill a hole 4 + 1 / 2 in (114.3 mm) deep, since it is 9 times the diameter in length. A 1 / 8 in (3.175 mm) diameter drill can drill a hole 1 + 5 / 8 in (41.275 mm) deep, since it is 13 times the diameter in flute length.
There were two ⌀3.2 mm negative pins spaced 9.5 mm apart and two ⌀4.0 mm positive pins spaced 14.3 mm apart. Negative and positive pins were spaced 18.1 mm apart. It was used in some early transistor radio amplifiers with a Class B output stage, allowing the loud speaker to be connected between the amplifier output and the battery center tap.
In addition, 10 mm (0.393 in), and letter X (0.397 in) will work well, although major minus pitch by itself does not tell you this; but the 90% ± 2 pp guideline supports it. For both of these rules of thumb (85%/90% and major minus pitch), the tap drill size yielded is not necessarily the only possible one, but it is a good one for general use.
For example, a 7/8 violin has a scale of about 317 mm, a 3/4-size instrument a scale of 307 mm, a half-size one 287 mm, and a quarter-size one 267 mm. 1/8, 1/10, 1/16 and 1/32 and even 1/64 violins also exist, becoming progressively smaller, but again in no proportional relationship. (A full-size instrument is described as 4/4.)
Get AOL Mail for FREE! Manage your email like never before with travel, photo & document views. Personalize your inbox with themes & tabs. You've Got Mail!
Although such information contains long lists of sieve sizes, in practice sieves are normally used in series in which each member sieve is selected to pass particles approximately 1/ √ 2 smaller in diameter or 1/2 smaller in cross-sectional area than the previous sieve. For example the series 80mm, 63, 40, 31.5, 20, 16, 14, 10, 8, 6.3, 4, 2.8 ...