Search results
Results from the WOW.Com Content Network
Hydropower is now used principally for hydroelectric power generation, and is also applied as one half of an energy storage system known as pumped-storage hydroelectricity. Hydropower is an attractive alternative to fossil fuels as it does not directly produce carbon dioxide or other atmospheric pollutants and it provides a relatively ...
Pumped-storage hydroelectricity (PSH), or pumped hydroelectric energy storage (PHES), is a type of hydroelectric energy storage used by electric power systems for load balancing. A PSH system stores energy in the form of gravitational potential energy of water, pumped from a lower elevation reservoir to a higher elevation. Low-cost surplus off ...
A magnetohydrodynamic generator (MHD generator) is a magnetohydrodynamic converter that transforms thermal energy and kinetic energy directly into electricity.An MHD generator, like a conventional generator, relies on moving a conductor through a magnetic field to generate electric current.
The first Edison hydroelectric power station, the Vulcan Street Plant, began operating September 30, 1882, in Appleton, Wisconsin, with an output of about 12.5 kilowatts. [16] By 1886 there were 45 hydroelectric power stations in the United States and Canada; and by 1889 there were 200 in the United States alone. [13]
The higher the heat rate (i.e. the more energy input that is required to produce one unit of electric output), the lower the efficiency of the power plant. The U.S. Energy Information Administration gives a general explanation for how to translate a heat rate value into a power plant's efficiency value. [4] Most power plants have a target or ...
Thus, "impulse" energy does work on the turbine. Maximum power and efficiency are achieved when the velocity of the water jet is twice the velocity of the rotating buckets, which, assuming that water jet collides elastically with the bucket, would mean the water leaves the bucket with zero velocity, thus imparting all kinetic energy to the wheel.
Low-head hydro power refers to the development of hydroelectric power where the head is typically less than 20 metres, although precise definitions vary. [1] Head is the vertical height measured between the hydro intake water level and the water level at the point of discharge.
The capacity factor can be calculated for any electricity producing installation, such as a fuel consuming power plant or one using renewable energy, such as wind, the sun or hydro-electric installations. The average capacity factor can also be defined for any class of such installations, and can be used to compare different types of ...