Search results
Results from the WOW.Com Content Network
Armor Level Protection NIJ HG1 9mm Luger.357 Magnum: This armor would protect against: 124 grain 9mm Luger Full Metal Jacketed Round Nose (FMJ RN) at a velocity of 1305 ft/s (398 m/s) 158 grain .357 Magnum Jacketed Soft Point (JSP) at a velocity of 1430 ft/s (436 m/s). This is roughly equivalent to the obsolete NIJ Level II ballistic protection ...
Steel armor panel (level III protection, variant called 6B23-1) is 6.3 mm thick and made of “44S” steel providing protection against bullets from an AKM assault rifle with a heat-strengthened core (cartridge 57-N-231) from 10 m, an AK-74 rifle (cartridges 7N22, 7N24), M16 rifle (M193 and M855 cartridges) from 25 m, and SVD rifle (57-N-323S ...
The Improved Outer Tactical Vest (IOTV) in MultiCam, as issued to United States Army soldiers. A bulletproof vest, also known as a ballistic vest or bullet-resistant vest, is a type of body armor designed to absorb impact and prevent the penetration of firearm projectiles and explosion fragments to the torso.
From 1999 to 2005, ZAO Artess produced and supplied 14,000 ballistic vests (among them 6B11-3, 6B17, 6B18, 6B24), to the Russian Armed Forces for 203 million roubles. The vests were purchased by Valery Znahurko, head of the supply department of the GRAU of the Ministry of Defense. Vests were mostly supplied to the North Caucasus Military District.
A call for a next generation plate, to stop even greater velocity threats than the ESAPI plate was issued by the U.S. Army in 2008. [5] The X Threat Small Arms Protective Insert plates are specifically allowed scalar or flexible systems, and asked for better coverage, with less than a pound of additional weight.
A ballistic plate, also known as an armour plate, is a protective armoured plate inserted into a carrier or bulletproof vest, that can be used stand-alone, or in conjunction with other armour. "Hard armour" usually denotes armour that uses ballistic plates. It serves to defeat higher threats, and may be considered as a form of applique armour.
(An unlikely prospect, given the muzzle velocity of a typical 9mm handgun or submachine gun). The Interceptor cannot, however, be called a Level III-A vest, since military standards do not require protection against heavy .44 Magnum ammunition. The vest will stop lower velocity fragments and has removable neck, throat, shoulder, extended back ...
The vest has Pouch Attachment Ladder System-type webbing loops stitched to the outside to act as attachment points for compatible pouches and accessories, removing the need to wear a webbing harness or assault vest over the armour (though a "Load Carrying Tactical Vest" was issued with early iterations of the armour). A grab handle on the rear ...