Search results
Results from the WOW.Com Content Network
Closet flanges are typically made of brass, cast iron, ABS, PVC, and lead. In a typical installation, the closet flange is mounted on top of the floor with the hub fused around the drain pipe. A wax ring (or waxless) is used to seal the gap between the flange and the bottom of the toilet. The toilet is bolted to the flange, not to the floor.
These are traditionally made out of beeswax. However, their proper sealing depends on proper seating of the water closet, on a firm and secure base (floor), and on proper installation of the closet bolts which secure the closet to the flange, which is in turn supposed to be securely fastened to the floor. [1]
Concrete will need to be poured to surround the trench drain so that the load can be transferred from the channel and grate to the surrounding areas. Pre-cast trench drains generally come in 4-inch (100 mm) widths but can range anywhere from a 1.75-inch (44 mm) slot to 2-inch (51 mm) wide channels with grates, and up to any size imaginable ...
A compression fitting 15 mm isolating valve. A compression fitting is a fitting used in plumbing and electrical conduit systems to join two tubes or thin-walled pipes together. . In instances where two pipes made of dissimilar materials are to be joined (most commonly PVC and copper), the fittings will be made of one or more compatible materials appropriate for the connect
A cement board is a combination of cement and reinforcing fibers formed into sheets, of varying thickness that are typically used as a tile backing board. [1] Cement board can be nailed or screwed to wood or steel studs to create a substrate for vertical tile and attached horizontally to plywood for tile floors, kitchen counters and backsplashes.
In domestic applications, traps are typically U, S, Q, or J-shaped pipe located below or within a plumbing fixture.An S-shaped trap is also known as an S-bend.It was invented by Alexander Cumming in 1775 but became known as the U-bend following the introduction of the U-shaped trap by Thomas Crapper in 1880.
A flange is a protruded ridge, lip or rim, either external or internal, that serves to increase strength (as the flange of a steel beam such as an I-beam or a T-beam); for easy attachment/transfer of contact force with another object (as the flange on the end of a pipe, steam cylinder, etc., or on the lens mount of a camera); or for stabilizing and guiding the movements of a machine or its ...
The dimension of a wide-flange I-beam. In the United States, steel I-beams are commonly specified using the depth and weight of the beam. For example, a "W10x22" beam is approximately 10 in (254 mm) in depth with a nominal height of the I-beam from the outer face of one flange to the outer face of the other flange, and weighs 22 lb/ft (33 kg/m).