Search results
Results from the WOW.Com Content Network
A trap primer (or trap seal primer) is a plumbing device or valve that adds water to traps.The water seals in traps are needed to prevent sewer gases from entering buildings, but because this water is exposed to the air, it is subject to evaporation over time in infrequently used floor drains, leading to the release of sewer gas into the environment.
The structure of the repeating unit of PPP Space-filling model of a short section of PPP. Poly(p-phenylene) (PPP) is made of repeating p-phenylene units, which act as the precursor to a conducting polymer of the rigid-rod polymer family. The synthesis of PPP has proven challenging, but has been accomplished through excess polycondensation with ...
Piping and instrumentation diagram of pump with storage tank. Symbols according to EN ISO 10628 and EN 62424. A more complex example of a P&ID. A piping and instrumentation diagram (P&ID) is defined as follows: A diagram which shows the interconnection of process equipment and the instrumentation used to control the process.
A process flow diagram (PFD) is a diagram commonly used in chemical and process engineering to indicate the general flow of plant processes and equipment. The PFD displays the relationship between major equipment of a plant facility and does not show minor details such as piping details and designations.
The Buchan trap was devised in the 19th century to stop the flow of sewer gases due to the miasma theory of disease. [1] For example, it was believed that the disease cholera was an airborne infection, not waterborne. The Buchan trap is normally found in the bottom of manholes or drop-shafts.
Anticlinal trap. An anticline is an area of the subsurface where the strata have been pushed into forming a domed shape. If there is a layer of impermeable rock present in this dome shape, then water-insoluble hydrocarbons can accumulate at the crest until the anticline is filled to the spill point (the highest point where hydrocarbons can escape the anticline).
A flame arrester during testing A flame arrester made for a 91 cm (36 inch) pipe weighing 10 tons. A flame arrester (also spelled arrestor), deflagration arrester, [1] or flame trap [2] is a device or form of construction that will allow free passage of a gas or gaseous mixture but will interrupt or prevent the passage of flame.
To use the template, list the parts of the diagram from left to right, separated by vertical-bar (pipe) characters (" | "). For example: