Search results
Results from the WOW.Com Content Network
MIL-STD-498 standard describes the development and documentation in terms of 22 Data Item Descriptions (DIDs), which were standardized documents for recording the results of each the development and support processes, for example, the Software Design Description DID was the standard format for the results of the software design process.
MIL-STD 461, "Requirements for the control of electromagnetic interference characteristics of subsystems and equipment" [18] MIL-STD-464, "Electromagnetic Environmental Effects Requirements for Systems" [19] MIL-STD-498, on software development and documentation [20] MIL-STD-499, on Engineering Management (System Engineering)
Data item descriptions. A United States data item description (DID) is a completed document defining the data deliverables required of a United States Department of Defense contractor. [ 1 ] A DID specifically defines the data content, format, and intended use of the data with a primary objective of achieving standardization objectives by the U ...
Succeeded by. MIL-STD-498. RTCA DO-178. DOD-STD-2167A (Department of Defense Standard 2167A), titled "Defense Systems Software Development", was a United States defense standard, published on February 29, 1988, which updated the less well known DOD-STD-2167 published 4 June 1985. This document established "uniform requirements for the software ...
It is preferred that articles in this category be listed by publishing identifier (MIL-STD-####) for consistency. Pages in category "Military of the United States standards" The following 46 pages are in this category, out of 46 total.
Data requirements can also be identified in the contract via special contract clauses (e.g., DFARS), which define special data provisions such as rights in data, warranty, etc. SOW guidance of MIL-HDBK-245D describes the desired relationship: "Work requirements should be specified in the SOW, and all data requirements for delivery, format, and ...
Waterfall model. The waterfall model is a breakdown of development activities into linear sequential phases, meaning they are passed down onto each other, where each phase depends on the deliverables of the previous one and corresponds to a specialization of tasks. [1] The approach is typical for certain areas of engineering design.
I will delete this section as unclear content and intent means I cannot try to fix it, there is no cite to try and interpret further, and the source is an ip 195.99.198.190 that seems to leave no way to Talk and nothing less to do.