Ads
related to: jib mounted tower ladder system
Search results
Results from the WOW.Com Content Network
A jib or jib arm is the horizontal or near-horizontal beam used in many types of crane to support the load clear of the main support. [1] [2] An archaic spelling is gib. [3] Usually jib arms are attached to a vertical mast or tower or sometimes to an inclined boom.
A level-luffing crane is a crane mechanism where the hook remains at the same level while luffing: moving the jib up and down, so as to move the hook inwards and outwards relative to the base. [1] Usually the description is only applied to those with a luffing jib that have some additional mechanism applied to keep the hook level when luffing.
The derrick tower can be a mast or a post with the bottom hinged at the base where all ropes meet. The top of the tower is secured with multiple reeved guys to position the top of the tower to the desired location by varying the length of the upper guy lines. The load is lifted using a pulley system connected to the top of the tower. [2]
A gin pole in use loading logs A gin pole used to install a weather vane atop the 200-foot steeple of a church Roof trusses being assembled with gin poles. A gin pole is a mast supported by one or more guy-wires that uses a pulley or block and tackle mounted on its upper end to lift loads.
A jib crane is a type of crane - not to be confused with a crane rigged with a jib to extend its main boom - where a horizontal member (jib or boom), supporting a moveable hoist, is fixed to a wall or to a floor-mounted pillar. Jib cranes are used in industrial premises and on military vehicles.
There are two common types of jib system, each controlled by a single hydraulic cylinder. Both systems can be used with either a single or dual rear pivot section. The articulating jib, also referred to as a tilting jib, is a simple a-frame. When extending the cylinder, the container/body is pushed up and back, exiting the rear locks.
Wing Enterprises is an American company headquartered in Springville, Utah company, the largest American manufacturer of ladders as of 2005. [1] The company produces the Little Giant Ladder System, a convertible aluminium ladder system. The founder of Wing Enterprises, Harold Ray "Hal" Wing, came across a prototype of the ladder in Germany in
The Fire Department of New York purchased two Sutphen 100+ tower ladder quints in 1981. They were the tallest tower ladders in the city [15] until they were taken out of service. Aerialscope only sold 75 foot towers until they developed 95 foot versions in 1985. The patch of Ladder 119 in Brooklyn still has an image of their Sutphen.
Ads
related to: jib mounted tower ladder system