Search results
Results from the WOW.Com Content Network
The routing configuration and usage of an aux-send will vary depending on the application. Two types of aux-sends commonly exist: pre-fader and post-fader. Pre-fader sends are not affected by the main fader for the channel, while post-fader sends are affected by the position of the main fader slider control for the channel.
If a send mix is configured post-fader, then the level sent to the send mix follows changes to the main channel strip fader. [22] This is useful for reverberation and other signal processor effects. An example of this is when an engineer would like to add some delay to the vocals – the fader can thus be used to adjust the amount of delay ...
The auxiliary send routes a split of the incoming signal to an auxiliary bus, which can then be routed to external devices. Auxiliary sends can either be pre-fader or post-fader, in that the level of a pre-fader send is set by the auxiliary send control, whereas post-fade sends depend on the position of the channel fader as well.
Until the 3.0 revision, very low data rates meant most A/V needed alternative connectors. USB-C can directly transport USB 3.1, DisplayPort, Thunderbolt, HDMI, and MHL protocols, with power, and audio and many other protocols are possible. Thunderbolt is the successor to FireWire, a generic high-speed data link with well-defined audio/video ...
Rather than tie up the high-bandwidth USB bus sending data to a slower USB device, the nearest high-bandwidth capable hub receives a SPLIT token followed by one or two USB packets at high-bandwidth, performs the data transfer at full- or low-bandwidth, and provides the response at high-bandwidth when prompted by a second SPLIT token.
Turbo coding is an iterated soft-decoding scheme that combines two or more relatively simple convolutional codes and an interleaver to produce a block code that can perform to within a fraction of a decibel of the Shannon limit.
Inserted devices can be connected in series to create a string of inserted devices. For instance, one could connect a gate, a compressor and an equalizer in series through the same channel's insert. Some digital mixers allow multiple internal effects to be inserted virtually, still others allow one or more third-party plugins to be inserted.
Many device interfaces or protocols (e.g., SATA, USB, SAS, PCIe) are used both inside many-device boxes, such as a PC, and one-device-boxes, such as a hard drive enclosure. Accordingly, this page lists both the internal ribbon and external communications cable standards together in one sortable table.