Search results
Results from the WOW.Com Content Network
The routing configuration and usage of an aux-send will vary depending on the application. Two types of aux-sends commonly exist: pre-fader and post-fader. Pre-fader sends are not affected by the main fader for the channel, while post-fader sends are affected by the position of the main fader slider control for the channel.
The auxiliary send routes a split of the incoming signal to an auxiliary bus, which can then be routed to external devices. Auxiliary sends can either be pre-fader or post-fader, in that the level of a pre-fader send is set by the auxiliary send control, whereas post-fade sends depend on the position of the channel fader as well.
If a send mix is configured post-fader, then the level sent to the send mix follows changes to the main channel strip fader. [22] This is useful for reverberation and other signal processor effects. An example of this is when an engineer would like to add some delay to the vocals – the fader can thus be used to adjust the amount of delay ...
Subgroups, auxiliary mixes, submixes or even the main outputs are routed through the matrix mixer to different loudspeaker zones, making the matrix essentially a "mix of mixes". [4] A front-of-house matrix may be used at a concert to switch between the headliner's and the opening act's mixing consoles. A matrix mixer feature may be included on ...
Until the 3.0 revision, very low data rates meant most A/V needed alternative connectors. USB-C can directly transport USB 3.1, DisplayPort, Thunderbolt, HDMI, and MHL protocols, with power, and audio and many other protocols are possible. Thunderbolt is the successor to FireWire, a generic high-speed data link with well-defined audio/video ...
Rather than tie up the high-bandwidth USB bus sending data to a slower USB device, the nearest high-bandwidth capable hub receives a SPLIT token followed by one or two USB packets at high-bandwidth, performs the data transfer at full- or low-bandwidth, and provides the response at high-bandwidth when prompted by a second SPLIT token.
For charging and data-transfer, the Pre uses a microUSB connector with USB 2.0 support, and audio output is supported by a standard 3.5 mm headphone jack. [27] While the phone reports support for the Bluetooth DUN protocol, Sprint has not permitted use of the Pre in tethered (or "Phone as Modem") mode. Verizon does support tethering via their ...
Inserted devices can be connected in series to create a string of inserted devices. For instance, one could connect a gate, a compressor and an equalizer in series through the same channel's insert. Some digital mixers allow multiple internal effects to be inserted virtually, still others allow one or more third-party plugins to be inserted.