Search results
Results from the WOW.Com Content Network
The Whisper family was developed as a line of accurate, multi-purpose cartridges using relatively heavy rifle bullets for a given caliber in subsonic loads. [1] [2] [3] The intention was to create an extremely accurate cartridge family for military, police, competition and specialized hunting markets that could also be easily sound suppressed.
Components of a modern bottleneck rifle cartridge. Top-to-bottom: Copper-jacketed bullet, smokeless powder granules, rimless brass case, Boxer primer.. Handloading, or reloading, is the practice of making firearm cartridges by manually assembling the individual components (metallic/polymer case, primer, propellant and projectile), rather than purchasing mass-assembled, factory-loaded ...
Subsonic ammunition is ammunition designed to operate at velocities below the speed of sound (Mach 1), which at standard conditions is 340.29 m/s (1,116.4 ft/s). This avoids the supersonic shockwave or "crack" of a supersonic bullet, which, particularly for suppressed firearms, influences the loudness of the shot.
The overall case length after the shortening and re-sizing is 1.565". The cartridge was designed to use .308" diameter bullets in weights of 110 to 150 grains, with a standard twist rate of 1-12". [1] Wilson Combat states that heavier bullets can be used in a barrel with a 1-8" twist rate for subsonic loads. [4]
The .308 Winchester has a 3.64 mL (56 gr H 2 O) cartridge case capacity. [9] The exterior shape of the case was designed to promote reliable case feeding and extraction in bolt-action rifles and machine guns alike, under extreme conditions. .308 Winchester maximum C.I.P. cartridge dimensions. All dimensions in millimeters (mm) and inches.
7.62mm Thumper is a barrel specification optimized to run larger bullets out of standard 7.62×39mm cases. [1] Barrels are cut to a standard 7.62×39mm "Russian" chamber but the bore ideally uses a faster 1:8" rifling twist rate in order to stabilize bullets heavier than 200gr at subsonic speeds. [2]
To manufacture cases for cartridges, a sheet of brass is punched into disks. These disks go through a series of drawing dies. The disks are annealed and washed before moving to the next series of dies. The brass needs to be annealed to remove the work-hardening in the material and make the brass malleable again ready for the next series of dies ...
The DSR-1 Subsonic is a variant optimized for 7.62×51mm NATO/.308 Winchester subsonic ammunition usage. The barrel length is reduced to 310 mm. The barrel length is reduced to 310 mm. The 8 inch twist rate of the barrel is especially adapted to stabilize the long heavy projectiles used in subsonic ammunition.