enow.com Web Search

  1. Ads

    related to: 48v to 12v reducer

Search results

  1. Results from the WOW.Com Content Network
  2. 48-volt electrical system - Wikipedia

    en.wikipedia.org/wiki/48-volt_electrical_system

    A 48 V system can provide more power, improve energy recuperation, [7] and allow up to an 85% decrease in cable mass. [10]12-volt systems can provide only 3.5 kilowatts, while a 48 V power could achieve 15 to 20 kW or even 50 kW. 48 volts is below the level that is considered safe in dry conditions without special protective measures. [11]

  3. Buck converter - Wikipedia

    en.wikipedia.org/wiki/Buck_converter

    To reduce voltage ripple, filters made of capacitors (sometimes in combination with inductors) are normally added to such a converter's output (load-side filter) and input (supply-side filter). [2] Its name derives from the inductor that “bucks” or opposes the supply voltage.

  4. Phantom power - Wikipedia

    en.wikipedia.org/wiki/Phantom_Power

    Phantom powering was first used for landline copper wire-based plain old telephone service since the introduction of the rotary dial telephone in 1919. One such application in the telephone system was to provide a DC signalling path around transformer-connected amplifiers such as analogue line transmission systems.

  5. Boost converter - Wikipedia

    en.wikipedia.org/wiki/Boost_converter

    Low-cost converter modules: two buck and one boost. Boost converter from a TI calculator, generating 9 V from 2.4 V provided by two AA rechargeable cells.. A boost converter or step-up converter is a DC-to-DC converter that increases voltage, while decreasing current, from its input to its output ().

  6. Power supply - Wikipedia

    en.wikipedia.org/wiki/Power_supply

    A capacitive power supply (transformerless power supply) uses the reactance of a capacitor to reduce the mains voltage to a smaller AC voltage. Typically, the resulting reduced AC voltage is then rectified, filtered and regulated to produce a constant DC output voltage.

  7. Inrush current limiter - Wikipedia

    en.wikipedia.org/wiki/Inrush_current_limiter

    A typical application of inrush current limiters is in the input stage of non-power factor corrected switching supplies, to reduce the initial surge of current from the line input to the reservoir capacitor. The most popular application is the inrush protection of the AC current in switching power supplies (SPS).

  1. Ads

    related to: 48v to 12v reducer