Search results
Results from the WOW.Com Content Network
Most rockets need to be supported and held down for a few seconds after ignition while the engines build up to full thrust. The vehicle is commonly held on the pad by hold-down arms or explosive bolts, which are triggered when the vehicle is stable and ready to fly, at which point all umbilical connections with the pad are released. [2]
The rocket was fired from two rails; aiming was simple, behind a shield the layer on the right hand side pushed the apparatus in the direction of the target using a crude sighting device and the layer on the left locked the launcher before the rocket was fired using electrical ignition. A test battery was set up at Aberporth and other rocket ...
A gravity turn is commonly used with rocket powered vehicles that launch vertically, like the Space Shuttle. The rocket begins by flying straight up, gaining both vertical speed and altitude. During this portion of the launch, gravity acts directly against the thrust of the rocket, lowering its vertical acceleration.
The rocket is launched using liquid hydrogen and liquid oxygen cryogenic propellants. Rocket propellant is used as reaction mass ejected from a rocket engine to produce thrust . The energy required can either come from the propellants themselves, as with a chemical rocket , or from an external source, as with ion engines .
Home Guards load a rocket launcher on a static 'Z' Battery on Merseyside, July 1942. The solid-fuel 3 in (76 mm) rocket used by the Z Batteries was known as the UP-3 (Unrotated Projectile) and had been developed in the late 1930s by the Projectile Development Establishment at Fort Halstead in Kent under the direction of Alwyn Crow.
The solid rocket motor ignition commands are issued when the three Space Shuttle Main Engines (SSMEs) are at or above 90% of rated thrust, no SSME fail and/or SRB ignition Pyrotechnic Initiator Controller (PIC) low voltage is indicated and there are no holds from the Launch Processing System (LPS).
Rutherford is a liquid-propellant rocket engine designed by aerospace company Rocket Lab [8] and manufactured in Long Beach, California. [9] The engine is used on the company's own rocket, Electron. It uses LOX (liquid oxygen) and RP-1 (refined kerosene) as its propellants and is the first flight-ready engine to use the electric-pump-fed cycle.
The rocket engine was a four-chamber design built by Reaction Motors Inc., one of the first companies to build liquid-propellant rocket engines in the U.S. After considering hydrogen peroxide monopropellant, aniline/nitric acid bipropellant, and nitromethane monopropellant as fuels, the rocket burned ethyl alcohol diluted with water with a ...