Search results
Results from the WOW.Com Content Network
Modem A begins dialing. Modem B's phone-line rings, and the modem reports the fact. ATA: Computer at modem B issues answer command. CONNECT: CONNECT: The modems connect, and both modems report "connect". (In practice, most modems report more information after the word CONNECT — specifying the speed of the connection.)
In network topology, a cable modem is a network bridge that conforms to IEEE 802.1D for Ethernet networking (with some modifications). The cable modem bridges Ethernet frames between a customer LAN and the coax network. Technically, it is a modem because it must modulate data to transmit it over the cable network, and it must demodulate data ...
Locatable Address Conversion System (LACS) is a service offered by the United States Postal Service to update mailing addresses when a street is renamed or the address is updated for 911. In the case of 911, the address is changed from a rural route format to an urban/city route format.
Modems always start out in command mode when powered up. Here are the ways a modem can switch to data mode: After a successful dial-out connection in response to an "ATD" dial command in which the modem reaches another modem. After answering the phone with the "ATA" answer command, if another modem is on the other end.
Label of a UMTS router with MAC addresses for LAN and WLAN modules. A MAC address (short for medium access control address or media access control address) is a unique identifier assigned to a network interface controller (NIC) for use as a network address in communications within a network segment.
2. Enter your username or email address and password. 3. Click Sign On. 4. Add your location name and connection type. 5. Click Next twice. 6. Select your dialing options. 7. Click Next. 8. Enter your Area Code and click Next. 9. Select 2-3 AOL access phone numbers. 10. Click Next twice to confirm your choices. 11. Click Save and then Save Changes.
A cable modem termination system (CMTS, also called a CMTS Edge Router) [1] is a piece of equipment, typically located in a cable company's headend or hubsite, which is used to provide data services, such as cable Internet or Voice over IP, to cable subscribers.
A typical volume of Bell System Practices from the 1970s. The Bell System Practices (BSPs) is a compilation of technical publications which describes the best methods of engineering, constructing, installing, and maintaining the telephone plant of the Bell System under direction of AT&T and Bell Telephone Laboratories. [1]