Search results
Results from the WOW.Com Content Network
Modem A begins dialing. Modem B's phone-line rings, and the modem reports the fact. ATA: Computer at modem B issues answer command. CONNECT: CONNECT: The modems connect, and both modems report "connect". (In practice, most modems report more information after the word CONNECT — specifying the speed of the connection.)
The modem also provides handshake protocols, so that the devices on each end of the connection are able to recognize each other. [6] However, a modem generally provides few other network functions. A USB modem plugs into a single PC and allows a connection of that single PC to a WAN. If properly configured, the PC can also function as the ...
Modems always start out in command mode when powered up. Here are the ways a modem can switch to data mode: After a successful dial-out connection in response to an "ATD" dial command in which the modem reaches another modem. After answering the phone with the "ATA" answer command, if another modem is on the other end.
The other end of the cord must be plugged securely into the modem jack labeled Line, Telco, or Wall. Note : For best results, the phone cord should go directly to the wall jack. Remove any splitters, phone line surge protectors, fax or answering machines, or other devices as they may affect your modem’s ability to connect.
In network topology, a cable modem is a network bridge that conforms to IEEE 802.1D for Ethernet networking (with some modifications). The cable modem bridges Ethernet frames between a customer LAN and the coax network. Technically, it is a modem because it must modulate data to transmit it over the cable network, and it must demodulate data ...
2. Enter your username or email address and password. 3. Click Sign On. 4. Add your location name and connection type. 5. Click Next twice. 6. Select your dialing options. 7. Click Next. 8. Enter your Area Code and click Next. 9. Select 2-3 AOL access phone numbers. 10. Click Next twice to confirm your choices. 11. Click Save and then Save Changes.
A label edge router (LER, also known as edge LSR) is a router that operates at the edge of an MPLS network and acts as the entry and exit points for the network. LERs push an MPLS label onto an incoming packet [b] and pop it off an outgoing packet.
In general, cable modem traffic is routed to other cable modems or to the Internet through a series of CMTSs and traditional routers. However, a route could conceivably pass through a single CMTS. A CCAP (Converged Cable Access Platform) combines CMTS and Edge QAM functionality in a single device so that it can provide both data (internet) with ...