Search results
Results from the WOW.Com Content Network
The issuance of a drawing from the engineering/design activity to the production activity. In other words, the event when a draft becomes a completed, official document. A stamp on the drawing saying "ISSUED" documents that RTP has occurred. RTV: room-temperature vulcanizing; return to vendor: 1. RTV sealants, a way to seal joints. 2.
LDS-1 (Line Drawing System-1) was a calligraphic (vector, rather than raster) display processor and display device created by Evans & Sutherland in 1969. [1] This model was known as the first graphics device with a graphics processing unit .
ISO Standards Handbook – Technical drawings, a broad collection of all basic ISO drawing standards Vol.1 Technical drawings in general, ISBN 92-67-10370-9; Vol.2 Mechanical engineering drawings, construction drawings, drawing equipment, ISBN 92-67-10371-7; ISO 128 Technical drawings—General principles of presentation
When part definition is defined mathematically via a solid model, the assertion that one cannot interrogate the model—the direct analog of "scaling the drawing"—becomes ridiculous; because when part definition is defined this way, it is not possible for a drawing or model to be "not to scale". A 2D pencil drawing can be inaccurately ...
ISO 5457:1999 Technical product documentation — Sizes and layout of drawing sheets; ISO 5459:2011 Geometrical product specifications (GPS) — Geometrical tolerancing — Datums and datum systems; ISO 5845-1:1995 Technical drawings — Simplified representation of the assembly of parts with fasteners — Part 1: General principles
[1] It is convenient to choose one face of the gear as the reference face and to mark it with the letter “I”. The other non-reference face might be termed face “II”. For an observer looking at the reference face, so that the tooth is seen with its tip uppermost, the right flank is on the right and the left flank is on the left.
An example of a multiview orthographic drawing from a US Patent (1913), showing two views of the same object. Third angle projection is used. In third-angle projection , the object is conceptually located in quadrant III, i.e. it is positioned below and behind the viewing planes, the planes are transparent , and each view is pulled onto the ...
Technical drawing with references and geometric specifications. A datum reference or just datum (plural: datums [Note 1]) is some geometrically important part of an object—such as a point, line, plane, hole, set of holes, or pair of surfaces—that serves as a reference in defining the geometry of the object and (often) in measuring aspects of the actual geometry to assess how closely they ...