Search results
Results from the WOW.Com Content Network
Thermoelectric cooling uses the Peltier effect to create a heat flux at the junction of two different types of materials. A Peltier cooler, heater, or thermoelectric heat pump is a solid-state active heat pump which transfers heat from one side of the device to the other, with consumption of electrical energy, depending on the direction of the current.
Thermoelectric temperature control is the use of the thermoelectric effect, specifically the Peltier effect, to heat or cool materials by applying an electrical current across them. [1] A typical Peltier cell absorbs heat on one side and produces heat on the other. [1] Because of this, Peltier cells can be used for temperature control. [1]
A thermoelectric generator (TEG), also called a Seebeck generator, is a solid state device that converts heat (driven by temperature differences) directly into electrical energy through a phenomenon called the Seebeck effect [1] (a form of thermoelectric effect).
The thermoelectric effect is the direct conversion of temperature differences to electric voltage and vice versa via a thermocouple. [1] A thermoelectric device creates a voltage when there is a different temperature on each side. Conversely, when a voltage is applied to it, heat is transferred from one side to the other, creating a temperature ...
The efficiency of a thermoelectric device for electricity generation is given by , defined as =.. The maximum efficiency of a thermoelectric device is typically described in terms of its device figure of merit where the maximum device efficiency is approximately given by [7] = + ¯ + ¯ +, where is the fixed temperature at the hot junction, is the fixed temperature at the surface being cooled ...
The Seebeck coefficient (also known as thermopower, [1] thermoelectric power, and thermoelectric sensitivity) of a material is a measure of the magnitude of an induced thermoelectric voltage in response to a temperature difference across that material, as induced by the Seebeck effect. [2]
After the JT expansion, point d, it has a temperature of 77.36 K (−195.79 °C; −320.42 °F) and a pressure of 1 bar. The liquid fraction is x. The liquid leaves the system at the bottom of the reservoir (point e) and the gas (fraction 1 − x) flows into the cold (low-pressure) side of the counterflow heat exchanger (point f). It leaves the ...
The service life of these generators is initially 10 years, and can be extended for another 5 to 10 years. [1] The core is also known as radioisotope heat source 90 (RHS-90). In its initial state after manufacture, the generator is capable of generating 10 watts of electricity . [ 3 ]