enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Open-circuit time constant method - Wikipedia

   en.wikipedia.org/wiki/Open-circuit_time_constant...

   An increase in this variable means the higher pole is further above the corner frequency. The y-axis is the ratio of the OCTC (open-circuit time constant) estimate to the true time constant. For the lowest pole use curve T_1; this curve refers to the corner frequency; and for the higher pole use curve T_2. The worst agreement is for τ 1 = τ 2.

3. Lead–lag compensator - Wikipedia

   en.wikipedia.org/wiki/Lead–lag_compensator

   The precise locations of the poles and zeros depend on both the desired characteristics of the closed loop response and the characteristics of the system being controlled. However, the pole and zero of the lag compensator should be close together so as not to cause the poles to shift right, which could cause instability or slow convergence.

4. Frequency compensation - Wikipedia

   en.wikipedia.org/wiki/Frequency_compensation

   The Transfer function of the compensated open loop Op-Amp circuit is given by: TF after Dominant pole compensation where f d < f 1 < f 2 < f 3. The compensation capacitance C is chosen such that f d < f 1. Hence, the frequency response of a dominant pole compensated open loop Op-Amp circuit shows uniform gain roll off from f d and becomes 0 at ...

5. Split-phase electric power - Wikipedia

   en.wikipedia.org/wiki/Split-phase_electric_power

   Single-pole circuit breakers feed 120 V circuits from one of the 120 V buses within the panel, or two-pole circuit breakers feed 240-volt circuits from both buses. 120 V circuits are the most common, and used to power NEMA 1 and NEMA 5 outlets, and most residential and light commercial direct-wired lighting circuits.

6. Pole splitting - Wikipedia

   en.wikipedia.org/wiki/Pole_splitting

   Pole splitting is a phenomenon exploited in some forms of frequency compensation used in an electronic amplifier.When a capacitor is introduced between the input and output sides of the amplifier with the intention of moving the pole lowest in frequency (usually an input pole) to lower frequencies, pole splitting causes the pole next in frequency (usually an output pole) to move to a higher ...

7. Clamper (electronics) - Wikipedia

   en.wikipedia.org/wiki/Clamper_(electronics)

   Clipper (electronics), a circuit that imposes a fixed limit and does not offset the signal; Envelope detector, a circuit that outputs the maximum (or minimum); a clamper with the diode and capacitor exchanged; Schottky diode; Snubber, a circuit that reduces dV/dt or limits peak voltage, in order to reduce arcing or breakdown