Search results
Results from the WOW.Com Content Network
New Process Gear A833 RPO MY6 or MM7 — 4-speed longitudinal A833 overdrive transmission made by New Process Gear for early to mid 1980s General Motors Light Trucks; Muncie SM465 — 4-speed longitudinal manual used in 68- 91 Chevy 1/2 3/4 and 1 ton trucks; New Venture Gear NV1500 — 5-speed longitudinal manual made by New Venture Gear
A manual transmission (MT), also known as manual gearbox, standard transmission (in Canada, the United Kingdom and the United States), or stick shift (in the United States), is a multi-speed motor vehicle transmission system where gear changes require the driver to manually select the gears by operating a gear stick and clutch (which is usually ...
These had a direct (1:1) fourth gear with an overdrive fifth gear, replacing the need for the separate overdrive gearbox. [1] With the popularity of front wheel drive cars, the separate gearbox and final drive have merged into a single transaxle. There is no longer a propeller shaft and so one meaning of "overdrive" can no longer be applied.
The TR-6070 is based on the TREMEC TR-6060 six-speed transmission. A triple overdrive gear was added to improve fuel economy and lower emissions. Incorporated in the TR-6070 is a Gear Absolute Position (GAP) sensor. The technology provides a signal from the transmission to the engine controller, inferring the real-time position of the shift ...
TREMEC engineers have recommended Texaco-Havoline Dexron III/Mercon Non-Synthetic ATF. There has been a significant amount of confusion regarding the proper capacity and proper type of ATF for the TR-3650 which may have a correlation with a rather large number of complaints about notchy shifting, shift "nibbling", noisy synchros, and grinding gears.
Manual – the driver has to perform each gear ... Truck transmission with overdrive top gear 5-speed & 6-speed ... 4, 5 or 6-speed with Hydraulic Retarder and ...
The Tremec TR-6060 six-speed manual transmission features six forward speeds and one reverse speed. It is derived from the Tremec T-56 6-speed manual transmission. As usual, the forward helical cut gears are synchronized. However, the reverse gear operates through a fully synchronized constant-mesh system.
The RL4R01A is a hydraulic controlled unit for its main operation. Shift timing is based on throttle cable position and governor pressure. Its only electronic parts are two solenoids, one for the torque converter clutch, and the other for the manual overdrive cancel switch, but these do not affect the gears control and passing.