Search results
Results from the WOW.Com Content Network
These valves are mounted on the outlet fittings of the fuel injection pump, one per cylinder injector. They are always mounted at the pump end of the pipes between the pump and injectors. The check valve aspect is a conical valve or 'mitre valve', [ i ] held against a matching conical seat by a spring.
Fuel is pumped from the tank to a large control valve called a fuel distributor, which divides the single fuel supply line from the tank into smaller lines, one for each injector. The fuel distributor is mounted atop a control vane through which all intake air must pass, and the system works by varying fuel volume supplied to the injectors ...
Injection phase Partway through the pump stroke, the solenoid is energized, which closes the spill valve. The fuel is forced into the cylinder through the spray tip. Pressure reduction phase Toward the end of the pump stroke, the spill valve is re-opened, allowing the fuel to recirculate again and ending the injection phase.
In most steam engine designs there is a short time at the end of the return stroke of the piston when all the valves are shut and it is compressing any remaining steam. Water can be introduced from the boiler or in a cold engine, steam will condense to water on the cool walls of the cylinders and can potentially hydrolock an engine.
PCV valve on Ford Taunus V4 engine (feeding from left side valve cover into the inlet manifold) A crankcase ventilation system (CVS) removes unwanted gases from the crankcase of an internal combustion engine. The system usually consists of a tube, a one-way valve and a vacuum source (such as the inlet manifold).
An idle air control actuator or idle air control valve (IAC actuator/valve) is a device commonly used in fuel-injected vehicles to control the engine's idling rotational speed . [1] In carburetted vehicles a similar device known as an idle speed control actuator is used.
The special feature of the unit injector system is that an individual pump is assigned to each cylinder; The pump and nozzle are therefore combined in a compact assembly which is installed directly in the cylinder head; The unit injector system enables high injection pressures up to 2,200 bar. Advantages: High performance for clean and powerful ...
Before the invention of precombustion chamber injection, air-blast injection was the only way a properly working internal air fuel mixture system could be built, required for a Diesel engine. During the 1920s, [2] air-blast injection was rendered obsolete by superior injection system designs that allowed much smaller but more powerful engines. [3]