Search results
Results from the WOW.Com Content Network
Many device interfaces or protocols (e.g., SATA, USB, SAS, PCIe) are used both inside many-device boxes, such as a PC, and one-device-boxes, such as a hard drive enclosure. Accordingly, this page lists both the internal ribbon and external communications cable standards together in one sortable table.
Ethernet over USB is the use of a USB link as a part of an Ethernet network, resulting in an Ethernet connection over USB (instead of e.g. PCI or PCIe).. USB over Ethernet (also called USB over Network or USB over IP) is a system to share USB-based devices over Ethernet, Wi-Fi, or the Internet, allowing access to devices over a network.
The idle line state is when the device is connected to the host with a pull-up on either D+ (for full speed USB 1.x) or D− (for low speed USB 1.x), with transmitter output on both host and device is set to high impedance (hi-Z) (disconnected output). A USB device pulls one of the data lines high with a 1.5 kΩ resistor.
The developer forums regulate the development of the USB connector, of other USB hardware, and of USB software; they are not end-user forums. In 2014, the USB-IF announced the availability of USB-C designs. USB-C connectors can transfer data with rates as much as 10 Gbit/s and provides as much as 100 watts of power. [4]
Thus, USB cables have different ends, A and B, with different physical connectors for each. Each format has a plug and receptacle defined for each of the A and B ends. A USB cable, by definition, has a plug on each end—one A (or C) and one B (or C)—and the corresponding receptacle is usually on a computer or electronic device.
USB 2.0 was released in April 2000, adding a higher maximum signaling rate of 480 Mbit/s (maximum theoretical data throughput 53 MByte/s [29]) named High Speed or High Bandwidth, in addition to the USB 1.x Full Speed signaling rate of 12 Mbit/s (maximum theoretical data throughput 1.2 MByte/s).
The Type-C specification does not name specific DP speeds that it considers supported for passive cables where support is optional for active cables. The USB-C presentation on DP Alt mode [47] calls out passive full-featured USB-C cables for their DisplayPort support and headroom for future DP speed increases. HBR3 was the highest available DP ...
USB communications device class (or USB CDC) is a composite Universal Serial Bus device class. The communications device class is used for computer networking devices akin to a network card , providing an interface for transmitting Ethernet or ATM frames onto some physical media.