Search results
Results from the WOW.Com Content Network
Blow extrusion of plastic film. The manufacture of plastic film for products such as food packages, shopping bags, and continuous sheeting is achieved using a blown film line. [5] This process is the same as a regular extrusion process up until the die. There are three main types of dies used in this process: annular (or crosshead), spider, and ...
The coating window is a multivariable map of key process parameters, describing the range over which they can be applied together to achieve a defect-free film. Understanding the coating window behavior of a typical slot-die process enables operators to observe defects in a slot-die coated layer and intuitively determine a course of action for ...
The polymer solution casting process utilizes a mandrel, or inner diameter mold, that is immersed in a tank of polymer solution or liquid plastic that has been specifically engineered for the process. Due to a combination of thermal and frictional properties, the polymer solution then forms a thin film around the mold. [1]
Die swell is an expansion of the melt as the pressure is released, and is dependent on polymer chemistry and die design. After curing, the solid, continuous part is drawn onto a take-up roller or cut into transportable lengths, depending on the type of part. This process may vary significantly depending on the type of die and extrusion process. [1]
This process is known as insert moulding and allows single parts to contain multiple materials. This process is often used to create plastic parts with protruding metal screws so they can be fastened and unfastened repeatedly. This technique can also be used for In-mould labelling and film lids may also be attached to moulded plastic containers.
This is a slower process but provides for higher cling quality. Blown film is not a consistent extrusion process, leading to inconsistencies across the film web. The cost of production is also higher due to the quantity that can be produced per hour. Cast: the film is extruded through a slot die, then passed over cooling rollers. This makes the ...
Evaporative-pattern casting is a type of casting process that uses a pattern made from a material that will evaporate when the molten metal is poured into the molding cavity. The most common evaporative-pattern material used is polystyrene foam. [1] The two major evaporative-pattern casting processes are: [1] Lost-foam casting; Full-mold casting
Ceramic mold casting, also known ambiguously as ceramic molding, [1] is a group of metal casting processes that use ceramics as the mold material. It is a combination of plaster mold casting and investment casting. [2] [3] There are two types of ceramic mold casting: the Shaw process and the Unicast process. [4]