Search results
Results from the WOW.Com Content Network
According to the equation listed above, increasing the trail and/or decreasing the head angle will increase the wheel flop factor on a bicycle or motorcycle, which will increase the torque required to bring the handlebars back to the straight ahead position and increase the vehicle's tendency to veer suddenly off the line of a curve.
Gear inches is one way of measuring the gear ratio(s) of a bicycle, so that different gears and different bicycles can be compared in a consistent manner. Gear inches is an imperial measure corresponding to the diameter in inches of the drive wheel of a penny-farthing bicycle with equivalent ( direct-drive ) gearing.
Total face width is the actual dimension of a gear blank including the portion that exceeds the effective face width, or as in double helical gears where the total face width includes any distance or gap separating right hand and left hand helices. For a cylindrical gear, effective face width is the portion that contacts the mating teeth.
Most modern manual motorcycle gearboxes have "constant-mesh" gears which are always mated but may rotate freely on a shaft until locked by a toothed sliding collar, or "dog clutch". Since the gears are always rotating and can only be accessed sequentially, synchromesh is not generally needed. To save space, both shafts may contain a mixture of ...
The steering ratio is the ratio between the theoretical turning radius based on ideal tire behavior and the actual turning radius. [9] Values less than one, where the front wheel side slip is greater than the rear wheel side slip, are described as under-steering ; equal to one as neutral steering; and greater than one as over-steering .
With power typically being the product of force and speed, a motorcycle's power and torque ratings will be highly indicative of its performance. Reported numbers for power and torque may however vary from one source to another due to inconsistencies in how testing equipment is calibrated, the method of using that equipment, the conditions during the test, and particularly the location that ...
The gearbox was designed so that, for efficiency, the fastest ratio would be a "direct-drive" or "straight-through" 1:1 ratio, avoiding frictional losses in the gears. Achieving an overdriven ratio for cruising thus required a gearbox ratio even higher than this, i.e. the gearbox output shaft rotating faster than the engine.
A steering ratio of x:y means that a turn of the steering wheel x degree(s) causes the wheel(s) to turn y degree(s). In most passenger cars , the ratio is between 12:1 and 20:1. For example, if one and a half turns of the steering wheel, 540 degrees, causes the inner & outer wheel to turn 35 and 30 degrees respectively, due to Ackermann ...