enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Split beam nut - Wikipedia

   en.wikipedia.org/wiki/Split_beam_nut

   A split beam nut, also known as a split hex nut [1] or slotted beam nut, [2] is a locknut with slots cut in the top that separate the outside end into two [3] or more sections that are bent slightly inward, making the thread diameter undersized in the slotted portion.

3. Flange nut - Wikipedia

   en.wikipedia.org/wiki/Flange_nut

   A self-aligning nut, also known as a spherical nut [2] or leveling nut, is a type of nut used in applications where the fastener is not perpendicular to the surface to which the nut anchors. A flange nut is used inside a specially shaped dished-out washer. The device is commonly used in the aerospace industry.

4. Nut (hardware) - Wikipedia

   en.wikipedia.org/wiki/Nut_(hardware)

   The cage has two wings that when compressed allow the cage to be inserted into the square holes Clip-on nut: J-nut or U-nut, sheet metal nut, speed nut (ambiguously) Designed to be clipped to sheet metal Coupling nut: Extension nut A threaded fastener for joining two male threads, most commonly a threaded rod,[1][2] but also pipes Flange nut ...

5. List of DIN standards - Wikipedia

   en.wikipedia.org/wiki/List_of_DIN_standards

   Hexagon slotted nuts and castle nuts with metric coarse and fine pitch thread – Product grades A and B: Active: DIN 935-2: M42 to M160x6 hexagon head nuts; product grade B: Active: DIN 935-3: Hexagon slotted nuts with metric coarse pitch thread – Product grade C: Active: DIN 936: M8 to M52 and M8x1 to M52x3 hexagon thin nuts; product grades ...

6. Distorted thread locknut - Wikipedia

   en.wikipedia.org/wiki/Distorted_thread_locknut

   A distorted thread locknut, [1] is a type of locknut that uses a deformed section of thread to keep the nut from loosening due to vibrations, or rotation of the clamped item. . There are four types: elliptical offset nuts, centerlock nuts, toplock nuts and partially depitched (Philidas) nu

7. List of screw and bolt types - Wikipedia

   en.wikipedia.org/wiki/List_of_screw_and_bolt_types

   They may either have a Phillips flat head or a slotted hex washer head. Nominal (thread) sizes range from 0.1875 to 0.375 in (4.763 to 9.525 mm) and lengths from 1.25 to 5 in (32 to 127 mm). Typically an installer uses a hammer drill to make a pilot hole for each concrete screw and a powered impact driver to drive the screw. The drill hole ...