enow.com Web Search

Search results

  1. Results from the WOW.Com Content Network
  2. Osmol gap - Wikipedia

    en.wikipedia.org/wiki/Osmol_gap

    The osmol gap is typically calculated with the following formula (all values in mmol/L): = = ([+] + [] + []) In non-SI laboratory units: Calculated osmolality = 2 x [Na mmol/L] + [glucose mg/dL] / 18 + [BUN mg/dL] / 2.8 + [ethanol/3.7] [3] (note: the values 18 and 2.8 convert mg/dL into mmol/L; the molecular weight of ethanol is 46, but empiric data shows that it does not act as an ideal ...

  3. Serum total protein - Wikipedia

    en.wikipedia.org/wiki/Serum_total_protein

    (It is also sometimes reported as "6.0-8.0g/dl"), [2] but this may vary depending on the method of analysis. Concentrations below the reference range usually reflect low albumin concentration, for instance in liver disease or acute infection. Rarely, low total protein may be a sign of immunodeficiency.

  4. Urea-to-creatinine ratio - Wikipedia

    en.wikipedia.org/wiki/Urea-to-creatinine_ratio

    For the adult male, the normal range is 0.6 to 1.2 mg/dl, or 53 to 106 μmol/L by the kinetic or enzymatic method, and 0.8 to 1.5 mg/dl, or 70 to 133 μmol/L by the older manual Jaffé reaction. For the adult female, with her generally lower muscle mass, the normal range is 0.5 to 1.1 mg/dl, or 44 to 97 μmol/L by the enzymatic method.

  5. Serum-ascites albumin gradient - Wikipedia

    en.wikipedia.org/wiki/Serum-ascites_albumin_gradient

    A high gradient (> 1.1 g/dL, >11 g/L) indicates the ascites is due to portal hypertension, either liver related or non-liver related, with approximately 97% accuracy. [2] This is due to increased hydrostatic pressure within the blood vessels of the hepatic portal system , which in turn forces water into the peritoneal cavity but leaves proteins ...

  6. Total iron-binding capacity - Wikipedia

    en.wikipedia.org/wiki/Total_iron-binding_capacity

    Transferrin (mg/dL) = 0.8 x TIBC (μg of iron/dL) – 43; Transferrin (mg/dL) = 0.7 x TIBC (μg of iron/dL) To measure TIBC in the blood is less expensive than a direct measurement of transferrin. [4] [5] The TIBC should not be confused with the unsaturated iron-binding capacity or UIBC (LOINC 2501-5, 22753-8 & 35216-1). The UIBC is calculated ...

  7. Delta ratio - Wikipedia

    en.wikipedia.org/wiki/Delta_Ratio

    Mathematically, if the change in the numerator is similar to the change in the denominator, the delta ratio will be close to 1. Since the anions are unable to diffuse out of the bloodstream, while bicarbonate and hydrogen ions diffuse with ease (as H 2 CO 3, carbonic acid), the usual result will be closer to a delta ratio of 1 to 2.

  8. AOL Mail

    mail.aol.com

    Get AOL Mail for FREE! Manage your email like never before with travel, photo & document views. Personalize your inbox with themes & tabs. You've Got Mail!

  9. Anion gap - Wikipedia

    en.wikipedia.org/wiki/Anion_gap

    The cations calcium (Ca 2+) and magnesium (Mg 2+) are also commonly measured, but they aren't used to calculate the anion gap. Anions that are generally considered "unmeasured" include a few normally occurring serum proteins, and some pathological proteins (e.g., paraproteins found in multiple myeloma). [citation needed]