enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. National pipe thread - Wikipedia

   en.wikipedia.org/wiki/National_pipe_thread

   The taper rate for all NPT threads is 1 inch of diameter in 16 inches of length (3 ⁄ 4 inch per foot or 62.5 millimeters per meter) measured by the change of diameter (of the pipe thread) over distance of thread. The half-angle (between the taper surface and the axis of the pipe) is arctan(1 ⁄ 32) ≈ 1.7899° ≈ 1° 47′.

3. Threaded pipe - Wikipedia

   en.wikipedia.org/wiki/Threaded_pipe

   Therefore many municipal plumbing codes restrict the use of threaded plastic pipe fittings. Both British standard and National pipe thread standards specify a thread taper of 1:16; the change in diameter is one sixteenth the distance travelled along the thread. The nominal diameter is achieved some small distance (the "gauge length") from the ...

4. Piping and plumbing fitting - Wikipedia

   en.wikipedia.org/wiki/Piping_and_plumbing_fitting

   Press fittings with appropriate and region-specific certification may be used for gas lines. Stainless steel and carbon steel press fittings can withstand up to 16 bars of pressure. A disadvantage of press fittings is the dead space between the pipe and the fitting, which can possibly rule out use for beverage and food applications.

5. AN thread - Wikipedia

   en.wikipedia.org/wiki/AN_thread

   A 37° flare type end fitting for flexible hose The AN thread (also A-N ) is a particular type of fitting used to connect flexible hoses and rigid metal tubing that carry fluid. It is a US military-derived specification that dates back to World War II and stems from a joint standard agreed upon by the Army Air Corps and Navy, hence AN.

6. Coupling (piping) - Wikipedia

   en.wikipedia.org/wiki/Coupling_(piping)

   Alternatively it is a short length of pipe with two female National pipe threads (NPT) (in North American terms, a coupler is a double female while a nipple is double male) or two male or female British standard pipe threads. If the two ends of a coupling are of different standards or joining methods, the coupling is called an adapter. Examples ...

7. JIC fitting - Wikipedia

   en.wikipedia.org/wiki/JIC_fitting

   JIC fittings, defined by the SAE J514 and MIL-DTL-18866 standards, are a type of flare fitting machined with a 37-degree flare seating surface. JIC (Joint Industry Council) fittings are widely used in fuel delivery and fluid power applications, especially where high pressure (up to 10,000 pounds per square inch (690 bar)) is involved.