enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Surface finishing - Wikipedia

   en.wikipedia.org/wiki/Surface_finishing

   One takes great care to remove any surface defects in the metal, like pits, that could allow bacteria to grow. A #4 dairy or sanitary finish is produced by polishing with a 180–240 grit belt or wheel finish softened with 120–240 grit greaseless compound or a fine non-woven abrasive belt or pad. #6 Finish. Also known as a fine satin finish.

3. Polished concrete - Wikipedia

   en.wikipedia.org/wiki/Polished_concrete

   The polishing process begins with a 50-grit diamond resin pad instead of a metal segment. When using the resin pads the steps may be 100, then 200, 400, 800, 1600 and finally 3000+ grit. Throughout the process, a densifier is used to harden the concrete surface, which allows the concrete to be polished.

4. Chemical-mechanical polishing - Wikipedia

   en.wikipedia.org/wiki/Chemical-mechanical_polishing

   The pad and wafer are pressed together by a dynamic polishing head and held in place by a plastic retaining ring. The dynamic polishing head is rotated with different axes of rotation (i.e., not concentric). This removes material and tends to even out any irregular topography, making the wafer flat or planar. This may be necessary to set up the ...

5. Brasso - Wikipedia

   en.wikipedia.org/wiki/Brasso

   Brasso has also been used to polish out scratches in plastics: It has been used to polish CDs, DVDs, screens, and pools to repair scratches. It is a mild solvent and an extremely fine abrasive, so when applied to the reflective surface of the disc and rubbed radially (in straight lines between the edge and centre), it can smooth scratches and reduce their effect.

6. Polishing (metalworking) - Wikipedia

   en.wikipedia.org/wiki/Polishing_(metalworking)

   The condition of the material at hand determines what type of abrasive will be applied. The first stage, if the material is unfinished, starts with a rough abrasive (perhaps 60 or 80 grit) and each subsequent stage uses a finer abrasive, such as 120, 180, 220/240, 320, 400 and higher grit abrasives, until the desired finish is achieved.

7. Etching (microfabrication) - Wikipedia

   en.wikipedia.org/wiki/Etching_(microfabrication)

   Etching tanks used to perform Piranha, hydrofluoric acid or RCA clean on 4-inch wafer batches at LAAS technological facility in Toulouse, France. Etching is used in microfabrication to chemically remove layers from the surface of a wafer during manufacturing.