Search results
Results from the WOW.Com Content Network
This is a list of the IP protocol numbers found in the field Protocol of the IPv4 header and the Next Header field of the IPv6 header. It is an identifier for the encapsulated protocol and determines the layout of the data that immediately follows the header. Both fields are eight bits wide.
The first header field in an IP packet is the Version field. For IPv4, this is always equal to 4. Internet Header Length (IHL): 4 bits The IPv4 header is variable in size due to the optional 14th field (Options). The IHL field contains the size of the IPv4 header; it has 4 bits that specify the number of 32-bit words in the header.
IPv4 is the fourth version in the development of the Internet Protocol, and routes most traffic on the Internet. [1] [non-primary source needed] The IPv4 header includes thirteen mandatory fields and is as small as 20 bytes. A fourteenth optional and infrequently used options field can increase the header size.
Packets that hold Internet Protocol data carry a 4-bit IP version number as the first field of its header. [ 1 ] [ 2 ] Currently, only IPv4 and IPv6 packets are seen on the Internet , having IP version numbers 4 and 6, respectively.
The Internet checksum, [1] [2] also called the IPv4 header checksum is a checksum used in version 4 of the Internet Protocol (IPv4) to detect corruption in the header of IPv4 packets. It is carried in the IP packet header, and represents the 16-bit result of summation of the header words. [3] The IPv6 protocol does not
IEN 44 Latest Header Formats (June 1978) describes another version of IPv4, also with a header different from the modern IPv4 header. IEN 54 Internetwork Protocol Specification Version 4 (September 1978) is the first description of IPv4 using the header that would become standardized in 1980 as RFC 760. IEN 80; IEN 111; IEN 123; IEN 128/RFC 760 ...
The type of service (ToS) field is the second byte of the IPv4 header. It has had various purposes over the years, and has been defined in different ways by five RFCs. [1] Prior to the redefinition, the ToS field could specify a datagram's priority and request a route for low-latency, high-throughput, or highly-reliable service.
The ICMP header starts after the IPv4 header and is identified by its protocol number, 1. [6] All ICMP packets have an eight-byte header and variable-sized data section. The first four bytes of the header have fixed format, while the last four bytes depend on the type and code of the ICMP packet.