enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Floor drain - Wikipedia

   en.wikipedia.org/wiki/Floor_drain

   A floor drain is a plumbing fixture that is installed in the floor of a structure, mainly designed to remove any standing water near it. They are usually round, but can also be square or rectangular. They usually range from 2 to 12 inches (5.1 to 30.5 cm); most are 4 inches (10 cm) in diameter.

3. Air gap (plumbing) - Wikipedia

   en.wikipedia.org/wiki/Air_gap_(plumbing)

   A standard widely use in the United States is: A112.1.2 Air Gaps in Plumbing Systems (For Plumbing Fixtures and Water-Connected Receptors) In the United Kingdom, legislation is by statutory instrument and varies by country, but includes Water Supply (Water Quality) Regulations 2016 and Water Supply (Water Quality) Regulations (Wales).

4. Plumbing drawing - Wikipedia

   en.wikipedia.org/wiki/Plumbing_drawing

   A plumbing drawing, a type of technical drawing, shows the system of piping for fresh water going into the building and waste going out, both solid and liquid. It also includes fuel gas drawings. Mainly plumbing drawing consist of water supply system drawings, drainage system drawings, irrigation system drawings, storm water system drawings.

5. Yes, You Need a Laundry Room Sink—We'll Explain Why - AOL

   www.aol.com/yes-laundry-room-sink-well-130000378...

   For premium support please call: 800-290-4726 more ways to reach us

6. Piping and plumbing fitting - Wikipedia

   en.wikipedia.org/wiki/Piping_and_plumbing_fitting

   Standard codes are followed when designing (or manufacturing) a piping system. Organizations which promulgate piping standards include: ASME: American Society of Mechanical Engineers A112.19.1 Enameled cast-iron and steel plumbing fixtures standards; A112.19.2 Ceramic plumbing fixtures standard

7. Tap (valve) - Wikipedia

   en.wikipedia.org/wiki/Tap_(valve)

   A fibre washer (which expands when wet, aiding the seal) is used between the connector and the tap tail. Tap tails are normally 1 ⁄ 2 " or 12 mm in diameter for sinks and 3 ⁄ 4 " or 19 mm for baths, although continental Europe sometimes uses a 3 ⁄ 8 " (still imperial) size.

8. These Laundry Rooms Are So Good You’ll Look Forward to ...

   www.aol.com/laundry-rooms-good-ll-look-150000463...

   In this cottage laundry room, a small, antique cast iron sink squeezes in right between the stacked washer and dryer and the wall. Above, a styled shelf adds a dose of personality. RELATED: The 82 ...

9. Drain-waste-vent system - Wikipedia

   en.wikipedia.org/wiki/Drain-waste-vent_system

   Double trapping is prohibited by plumbing codes due to its susceptibility to clogging. In the U.S., every plumbing fixture must also be coupled to the system's vent piping. [1] Without a vent, negative pressure can slow the flow of water leaving the system, resulting in clogs, or cause siphonage to empty a trap. The high point of the vent ...