Search results
Results from the WOW.Com Content Network
Laurell Technologies WS-400 spin coater used to apply photoresist to the surface of a silicon wafer. Spin coating is a procedure used to deposit uniform thin films onto flat substrates. Usually a small amount of coating material in liquid form is applied on the center of the substrate, which is either spinning at low speed or not spinning at all.
For example, a whole car has been coated with spray assembly, optically transparent films have been prepared with spin assembly, etc. [1] Characterization of LbL film deposition is typically done by optical techniques such as dual polarisation interferometry or ellipsometry or mechanical techniques such as quartz crystal microbalance. [citation ...
Spin casting is a favored method for fabricating items in the specified materials – low temperature metals and thermoset plastics. Compared to the two main competing processes, injection molding and (zinc) die-casting, spin casting has significant advantages in terms of startup cost and ease of use.
There are four basic parameters that are involved in spin coating: solution viscosity, solid content (density), angular speed, and spin time. [13] A range of thicknesses can be achieved by spin coating. Most commonly the thicknesses range from 1-200 μm. The main properties that affect the thickness of the film are viscosity and spin speed.
The precursor sol can be either deposited on a substrate to form a film (e.g., by dip-coating or spin coating), cast into a suitable container with the desired shape (e.g., to obtain monolithic ceramics, glasses, fibers, membranes, aerogels), or used to synthesize powders (e.g., microspheres, nanospheres). [1]
Health insurance industry officials remain uncharacteristically reserved in the aftermath of the fatal shooting of UnitedHealthcare CEO Brian Thompson on Dec. 4.. A week after the attack, the ...
“Being a parent is probably the hardest job all of us have,” Tom began during the discussion. “And we screw up a lot and I’ve screwed up a lot as a parent.
When dry films are used, the photoresist is laminated rather than spin-coated. As this formulation is essentially solventless (less than 1% solvent remaining), it does not require a soft bake step and does not suffer stress or skinning. For enhanced adhesion, a post lamination bake can be added. This step is carried out in a similar way to the ...