enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Washer (hardware) - Wikipedia

   en.wikipedia.org/wiki/Washer_(hardware)

   Washers of standard metric sizes equivalent to BS4320 Form A are listed in the table below. Measurements in the table refer to the dimensions of the washers as described by the drawing. Specifications for standard metric flat washers were known as DIN 125 (withdrawn) and replaced with ISO 7089.

3. List of DIN standards - Wikipedia

   en.wikipedia.org/wiki/List_of_DIN_standards

   Product grade A washers – with a hardness up to 300 HV designed for use with hexagon head bolts and nuts: Withdrawn: DIN EN ISO 7089, DIN EN ISO 7090: ISO 7089, ISO 7090: DIN 126: Product grade C washers – designed for use with hexagon head bolts and nut: Withdrawn: DIN EN ISO 7091: ISO 7091: DIN 127: Spring lock washers with square ends or ...

4. List of screw and bolt types - Wikipedia

   en.wikipedia.org/wiki/List_of_screw_and_bolt_types

   They may either have a Phillips flat head or a slotted hex washer head. Nominal (thread) sizes range from 0.1875 to 0.375 in (4.763 to 9.525 mm) and lengths from 1.25 to 5 in (32 to 127 mm). Typically an installer uses a hammer drill to make a pilot hole for each concrete screw and a powered impact driver to drive the screw.

5. Wrench size - Wikipedia

   en.wikipedia.org/wiki/Wrench_size

   Sizes that may interchange, depending on the precision needed, include 2 mm (close to 5 ⁄ 64 inch (1.98 mm)), 4 mm (close to 5 ⁄ 32 inch (3.97 mm)) and 8 mm (close to 5 ⁄ 16 inch (7.94 mm)). In reality, a wrench with a width across the flats of exactly 15 mm would fit too tightly to use on a bolt with a width across the flats of 15 mm.

6. United States Standard thread - Wikipedia

   en.wikipedia.org/wiki/United_States_Standard_thread

   The thread form is defined by flats at the tip and root of the thread form. This flat length is defined as the pitch divided by eight. The thread depth, which is from flat to flat is 0.6495 times the pitch. [4] For 1 ⁄ 4-inch (6.4 mm) screws and larger, the pitch is defined as: = +

7. British Standard Whitworth - Wikipedia

   en.wikipedia.org/wiki/British_Standard_Whitworth

   British Standard Whitworth (BSW) is an imperial-unit-based screw thread standard, devised and specified by Joseph Whitworth in 1841 and later adopted as a British Standard. It was the world's first national screw thread standard, and is the basis for many other standards, such as BSF , BSP , BSCon , and BSCopper .