Search results
Results from the WOW.Com Content Network
It is frequently used to implement the serial port for IBM PC compatible personal computers, where it is often connected to an RS-232 interface for modems, serial mice, printers, and similar peripherals. It was the first serial chip used in the IBM PS/2 line, which were introduced in 1987. [2] [3] [4] The part was originally made by National ...
Synchronous Data Link Control (SDLC) is a computer serial communications protocol first introduced by IBM as part of its Systems Network Architecture (SNA). SDLC is used as layer 2, the data link layer , in the SNA protocol stack .
MII has two signal interfaces: A Data interface to the Ethernet MAC, for sending and receiving Ethernet frame data. A PHY management interface, MDIO, used to read and write the control and status registers of the PHY in order to configure each PHY before operation, and to monitor link status during operation.
Stop (logic high (1)): the next one or two bits are always in the mark (logic high, i.e., 1) condition and called the stop bit(s). They signal to the receiver that the character is complete. Since the start bit is logic low (0) and the stop bit is logic high (1) there are always at least two guaranteed signal changes between characters.
The bus is a multi-controller bus, which means that any number of controller nodes can be present. Additionally, controller and target roles may be changed between messages (after a STOP is sent). There may be four potential modes of operation for a given bus device, although most devices only use a single role and its two modes:
Another message was sent out about 12 hours later Friday morning. The message stated: "This is an emergency message from the Los Angeles County Fire Department. An EVACUATION WARNING has been ...
A U.S. judge on Friday said Southwest Airlines must face a lawsuit by a prominent affirmative action opponent claiming a now-defunct program that awarded free flights to Hispanic college students ...
Asynchronous serial communication is a form of serial communication in which the communicating endpoints' interfaces are not continuously synchronized by a common clock signal. Instead of a common synchronization signal, the data stream contains synchronization information in form of start and stop signals, before and after each unit of ...