enow.com Web Search

Search results

  1. Results from the WOW.Com Content Network
  2. route (command) - Wikipedia

    en.wikipedia.org/wiki/Route_(command)

    -f: Clears the routing table-p: The route is added to the Windows Registry and is used to initialize the IP routing table whenever the TCP/IP protocol is started (only when used with the add command) Command: The command to run (add, change, delete, print)-4: Force using IPv4-6: Force using IPv6; Destination: Network destination of the route

  3. netsh - Wikipedia

    en.wikipedia.org/wiki/Netsh

    In computing, netsh, or network shell, is a command-line utility included in Microsoft's Windows NT line of operating systems beginning with Windows 2000. [1] It allows local or remote configuration of network devices such as the interface .

  4. Windows Vista networking technologies - Wikipedia

    en.wikipedia.org/wiki/Windows_Vista_networking...

    For this reason, ECN is disabled by default. It can be enabled via the netsh interface tcp set global ecncapability=enabled command. [3] In previous versions of Windows, all processing needed to receive or transfer data over one network interface was done by a single processor, even in a multi processor system.

  5. Routing table - Wikipedia

    en.wikipedia.org/wiki/Routing_table

    The network address and subnet mask of the interface, along with the interface type and number, are entered into the routing table as a directly connected network. A remote network is a network that can only be reached by sending the packet to another router. Routing table entries to remote networks may be either dynamic or static.

  6. IP routing - Wikipedia

    en.wikipedia.org/wiki/IP_routing

    eth0 is the interface name of the network interface card representing an Ethernet port. ppp0 is a PPPoE interface, which is configured as the default route in this example. A default route is recognized by the destination 0.0.0.0 and the flag G. A network router is identified by the network mask 255.255.255.255 and the flag H.

  7. iproute2 - Wikipedia

    en.wikipedia.org/wiki/Iproute2

    Replacement command Note ifconfig: ip addr, ip link: Address and link configuration route: ip route: Routing tables arp: ip neigh: Neighbors iptunnel: ip tunnel: Tunnels nameif, ifrename: ip link set name: Rename network interfaces ipmaddr: ip maddr: Multicast netstat: ss, ip route: Show various networking statistics brctl: bridge: Handle ...

  8. Routing protocol - Wikipedia

    en.wikipedia.org/wiki/Routing_protocol

    Routing protocols, according to the OSI routing framework, are layer management protocols for the network layer, regardless of their transport mechanism: IS-IS runs on the data link layer (Layer 2) Open Shortest Path First (OSPF) is encapsulated in IP, but runs only on the IPv4 subnet, while the IPv6 version runs on the link using only link ...

  9. Protocol-dependent module - Wikipedia

    en.wikipedia.org/wiki/Protocol-dependent_module

    Redistribute routing information that was learned by other IP-capable routing protocols." [1] When a newly discovered neighbor is learned, the address and interface of the neighbor are recorded, and this information is held in the neighbor table, stored in RAM. There is one neighbor table per each protocol-dependent module. [2]