Search results
Results from the WOW.Com Content Network
This is an incomplete list of DIN standards.. The "STATUS" column gives the latest known status of the standard.. If a standard has been withdrawn and no replacement specification is listed, either the specification was withdrawn without replacement or a replacement specification could not be identified.
A spline is a ridge or tooth [1] [2] [3] on a drive shaft that matches with a groove in a mating piece and transfers torque to it, maintaining the angular correspondence between them. For instance, a gear mounted on a shaft might use a male spline on the shaft that matches the female spline on the gear.
Shaft angle. A shaft angle is the angle between the axes of two non-parallel gear shafts. In a pair of crossed helical gears, the shaft angle lies between the oppositely rotating portions of two shafts. This applies also in the case of worm gearing. In bevel gears, the shaft angle is the sum of the two
Hirth joint made from anodized aluminum to show the meshing of the teeth Hirth joint (disassembled) between the semi-axles of a Campagnolo Ultra-Torque crankset. Face spline joints consist of a ring of radial splines or teeth milled or ground into the end faces of two rotary components such as a drive shaft and the hub of a wheel.
35 Spline axle shafts with a 1.5 in (38 mm) diameter; Ratios 3.08 to 4.30. Current production ratios offered are 3.31, 3.55, 3.73, and 4.30. Since ca. 2005, the gears are formed by the face hob process, formerly face milled process.
Hobbing is a machining process for gear cutting, cutting splines, and cutting sprockets using a hobbing machine, a specialized milling machine.The teeth or splines of the gear are progressively cut into the material (such as a flat, cylindrical piece of metal or thermoset plastic) by a series of cuts made by a cutting tool called a hob.
Discover the best free online games at AOL.com - Play board, card, casino, puzzle and many more online games while chatting with others in real-time.
The following stresses are induced in the shafts. Shear stresses due to the transmission of torque (due to torsional load). Bending stresses (tensile or compressive) due to the forces acting upon the machine elements like gears and pulleys as well as the self weight of the shaft. Stresses due to combined torsional and bending loads.