enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Wheel hub assembly - Wikipedia

   en.wikipedia.org/wiki/Wheel_hub_assembly

   A roller bearing between the axle hub and axle shaft ensures easy rotation of the non-drive wheels. On the axle side, it is mounted to the holding bracket from the chassis; on the disc side, the wheel is mounted to the bolts of the WHA. When replacing, a wheel hub assembly should be torqued to the vehicle's specifications to prevent failure. [1]

3. Transverse leaf spring front suspension - Wikipedia

   en.wikipedia.org/wiki/Transverse_leaf_spring...

   Transverse leaf spring front suspension is a type of automotive front suspension, whose usage is most well known in Ford Motor Company products from 1908 to 1948 (1959 for the inexpensive Ford Popular in the UK). "Suicide front axle" is a term that has been used for it. [1] The configuration consists of a one-piece axle (solid front axle), to ...

4. Kingpin (automotive part) - Wikipedia

   en.wikipedia.org/wiki/Kingpin_(automotive_part)

   Kingpins were always clamped in the centre and the swivel bearings at the ends, to increase the lever arm and so reduce the bearing load. Independent front suspension developed through the 1930s, for high-performance cars at least, often using double wishbone suspension. This performance also encouraged the reduction of unsprung weight.

5. Locking hubs - Wikipedia

   en.wikipedia.org/wiki/Locking_hubs

   Locking hubs, also known as free wheeling hubs are fitted to some (mainly older) four-wheel drive vehicles, allowing the front wheels to rotate freely when disconnected (unlocked) from the front axle. This is done to reduce the mechanical resistance of the front-portion of the drivetrain when four-wheel drive is not in use. [1]

6. Ball joint - Wikipedia

   en.wikipedia.org/wiki/Ball_joint

   Unlike a kingpin, which requires an assembly in the center of the wheel in order to pivot, joints connect to the upper and lower end of the spindle (steering knuckle), to the control arms. This leaves the center section open to allow the use of front-wheel drive. Older kingpin designs can only be used in a rear-wheel-drive configuration.

7. Double wishbone suspension - Wikipedia

   en.wikipedia.org/wiki/Double_wishbone_suspension

   Attached to the knuckle at its center is a bearing hub, or in many older designs, a spindle to which the wheel bearings are mounted. To resist fore-aft loads such as acceleration and braking, the arms require two bushings or ball joints at the body. Double wishbone suspension in action, displayed at the Toyota Museum in Nagoya, Japan