Search results
Results from the WOW.Com Content Network
In the above formula, P is measured in units of power, such as watts (W) or milliwatts (mW), and the signal-to-noise ratio is a pure number. However, when the signal and noise are measured in volts (V) or amperes (A), which are measures of amplitude, [note 1] they must first be squared to obtain a quantity proportional to power, as shown below:
Signal to Noise (The Rise album), a 2002 album by the band The Rise; Signal to Noise (White Willow album), a 2006 album by the Norwegian art-rock band White Willow; Signal to Noise, a 2015 album by Andy Jackson "Signal to Noise", a song from Peter Gabriel’s 2002 album Up "Signal to Noise", a song included as a B-side from The Cure's single ...
is the carrier-to-noise ratio or signal-to-noise ratio, B is the channel bandwidth in hertz, and f s {\displaystyle f_{s}} is the symbol rate in baud or symbols per second.
In telecommunications, the carrier-to-noise ratio, often written CNR or C/N, is the signal-to-noise ratio (SNR) of a modulated signal. The term is used to distinguish the CNR of the radio frequency passband signal from the SNR of an analog base band message signal after demodulation. For example, with FM radio, the strength of the 100 MHz ...
The ratio of (a) total received power, i.e., the signal to (b) the noise-plus-distortion power. This is modeled by the equation above. [2] The ratio of (a) the power of a test signal, i.e. a sine wave, to (b) the residual received power, i.e. noise-plus-distortion power. With this definition, it is possible to have a SINAD level less than one.
An application of the channel capacity concept to an additive white Gaussian noise (AWGN) channel with B Hz bandwidth and signal-to-noise ratio S/N is the Shannon–Hartley theorem: C = B log 2 ( 1 + S N ) {\displaystyle C=B\log _{2}\left(1+{\frac {S}{N}}\right)\ }
In the simple version above, the signal and noise are fully uncorrelated, in which case + is the total power of the received signal and noise together. A generalization of the above equation for the case where the additive noise is not white (or that the / is not constant with frequency over the bandwidth) is obtained by treating the channel as many narrow, independent Gaussian ...
Pulse compression is a signal processing technique commonly used by radar, sonar and echography to either increase the range resolution when pulse length is constrained or increase the signal to noise ratio when the peak power and the bandwidth (or equivalently range resolution) of the transmitted signal are constrained.