Search results
Results from the WOW.Com Content Network
where this time is the charge density, is the current density vector, and is the current source-sink term. The current source and current sinks are where the current density emerges > or vanishes <, respectively (for example, the source and sink can represent the two poles of an electrical battery in a closed circuit).
The two resistors form a voltage divider to produce a control voltage Vc = Vs * (Rc / (Rc + Rs)) where Vc is the returned control voltage, Vs is the source voltage, Rc is the variable control resistance, and Rs is the source resistance. Vs may be greater than 10 V so that a maximum intended value of Rc produces a 10 V maximum control voltage ...
If all inputs are high, each buffer will be in a high-impedance state and the pull-up resistor will pull the output high. But if any input is low, the output will be pulled low by the buffer for that input. This corresponds to wired AND in active-high logic, or to wired OR in active-low logic, and allows multiple inputs to share the same output ...
A current source is the dual of a voltage source. The term current sink is sometimes used for sources fed from a negative voltage supply. Figure 1 shows the schematic symbol for an ideal current source driving a resistive load. There are two types. An independent current source (or sink) delivers a constant current.
Depending on the source of current for the loop, devices may be classified as active (supplying or "sourcing" power) or passive (relying on or "sinking" loop power). For example, a chart recorder may provide loop power to a pressure transmitter. The pressure transmitter modulates the current on the loop to send the signal to the strip chart ...
Fan-out is ultimately determined by the maximum source and sink currents of an output and the maximum source and sink currents of the connected inputs; the driving device must be able to supply or sink at its output the sum of the currents needed or provided (depending on whether the output is a logic high or low voltage level) by all of the ...
SOURCE: Integrated Postsecondary Education Data System, Washington State University (2014, 2013, 2012, 2011, 2010). Read our methodology here. HuffPost and The Chronicle examined 201 public D-I schools from 2010-2014. Schools are ranked based on the percentage of their athletic budget that comes from subsidies.
Compact PLC with 8 inputs and 4 outputs Modular PLC with EtherNet/IP module, discrete and analog I/O, with some slots being empty There are four types of mechanical design for PLC systems. A single box (also called a brick ) is a small programmable controller that fits all units and interfaces into one compact casing, although, typically ...