Search results
Results from the WOW.Com Content Network
In telecommunications, effective data transfer rate is the average number of units of data, such as bits, characters, blocks, or frames, transferred per unit time from a source and accepted as valid by a sink. Note: The effective data transfer rate is usually expressed in bits, characters, blocks, or frames per second. The effective data ...
In order to calculate the data transmission rate, one must multiply the transfer rate by the information channel width. For example, a data bus eight-bytes wide (64 bits) by definition transfers eight bytes in each transfer operation; at a transfer rate of 1 GT/s, the data rate would be 8 × 10 9 B /s, i.e. 8 GB/s, or approximately 7.45 GiB /s.
WAN optimization is a collection of techniques for improving data transfer across wide area networks (WANs). In 2008, the WAN optimization market was estimated to be $1 billion, [1] and was to grow to $4.4 billion by 2014 according to Gartner, [2] a technology research firm.
People are often concerned about measuring the maximum data throughput in bits per second of a communications link or network access. A typical method of performing a measurement is to transfer a 'large' file from one system to another system and measure the time required to complete the transfer or copy of the file.
The latter will increase the data transfer rate for a given RPM speed. Improvement of data transfer rate performance is correlated to the areal density only by increasing a track's linear surface bit density (sectors per track). Simply increasing the number of tracks on a disk can affect seek times but not gross transfer rates.
Bandwidth commonly measured in bits/second is the maximum rate that information can be transferred; Throughput is the actual rate that information is transferred; Latency the delay between the sender and the receiver decoding it, this is mainly a function of the signals travel time, and processing time at any nodes the information traverses
The figures below are simplex data rates, which may conflict with the duplex rates vendors sometimes use in promotional materials. Where two values are listed, the first value is the downstream rate and the second value is the upstream rate. The use of decimal prefixes is standard in data communications.
Therefore, transferring data as a bulk would yield a better performance in terms of higher throughput. Sliding window flow control is a point to point protocol assuming that no other entity tries to communicate until the current data transfer is complete. The window maintained by the sender indicates which frames it can send.