Search results
Results from the WOW.Com Content Network
The result is expressed in inches and is usually (but not always) rounded to a convenient fraction. For instance, a 6.4x4.8 mm sensor has a diagonal of 8.0 mm and therefore an optical format of 8.0*3/2 = 12 mm, which is expressed as 1 ⁄ 2 inch in imperial units. The reason it is expressed in inches is historical, dating back to the early days ...
Although the most common medium format film, the 120 roll, is 6 cm (2.4 in) wide, and is most commonly shot square, the most common "medium-format" digital sensor sizes are approximately 48 mm × 36 mm (1.9 in × 1.4 in), which is roughly twice the size of a full-frame DSLR sensor format.
English: a ruler from 0 to 1 inch (in.) in 1/32 inch divisions below the line and 1/2 millimetre (mm) divisions above the line to give a visual representation of the approximations. Principally designed to help visually determine if a metric or imperial drill bit will suffice.
By default, the output value is rounded to adjust its precision to match that of the input. An input such as 1234 is interpreted as 1234 ± 0.5, while 1200 is interpreted as 1200 ± 50, and the output value is displayed accordingly, taking into account the scale factor used in the conversion.
When using "hand in" to convert to hands and inches, the rounded hands and inches values are equivalent, and use the same fraction, if any. Special rounding of the inches value only occurs when "hand in" is the output. For example, if the output is "in hand", the inches value is rounded independently from the hands value.
The Charrière is measured by the ''outer'' diameter, and is defined as 1 Fr = 1/3 mm, and thus 1 mm = 3 Fr; therefore the diameter of a round catheter in millimetres can be determined by dividing the French size by 3. [2] The French units roughly correspond to the outer circumference of the catheter (see table below).
6. Spare Keys. Spare keys in your wallet might seem like a good idea — until you lose them. Now, some random guy could be two steps away from showing himself in. Better call: leave a spare with ...
A few sizes are close enough to interchange for most purposes, such as 19 mm (close to 3 ⁄ 4 inch (19.05 mm)), 8 mm (close to 5 ⁄ 16 inch (7.94 mm)) and 4 mm (close to 5 ⁄ 32 inch (3.97 mm)). In reality, a wrench with a width across the flats of exactly 15 mm would fit too tightly to use on a bolt with a width across the flats of 15 mm.