Search results
Results from the WOW.Com Content Network
In telecommunication and data transmission, serial communication is the process of sending data one bit at a time, sequentially, over a communication channel or computer bus. This is in contrast to parallel communication , where several bits are sent as a whole, on a link with several parallel channels.
In data transmission, parallel communication is a method of conveying multiple binary digits simultaneously using multiple conductors. This contrasts with serial communication , which conveys only a single bit at a time; this distinction is one way of characterizing a communications link .
Buses can be parallel buses, which carry data words in parallel on multiple wires, or serial buses, which carry data in bit-serial form. The addition of extra power and control connections, differential drivers , and data connections in each direction usually means that most serial buses have more conductors than the minimum of one used in 1 ...
While interfaces such as Ethernet, FireWire, and USB also send data as a serial stream, the term serial port usually denotes hardware compliant with RS-232 or a related standard, such as RS-485 or RS-422. Modern consumer personal computers (PCs) have largely replaced serial ports with higher-speed standards, primarily USB.
(the START bit), waits 'half a bit duration' and then reads the value of the signal. A further delay of one 'whole bit duration' is executed before the next data bit is 'read' - repeating for the length of the whole serial word (typically 7/8-data bits). An optional PARITY bit follows the data bits and precedes the stop bit(s).
In general, parallel interfaces are quoted in B/s and serial in bit/s. The more commonly used is shown below in bold type. On devices like modems , bytes may be more than 8 bits long because they may be individually padded out with additional start and stop bits; the figures below will reflect this.
In computing, a parallel port is a type of interface found on early computers (personal and otherwise) for connecting peripherals. The name refers to the way the data is sent; parallel ports send multiple bits of data at once (parallel communication), as opposed to serial communication, in which bits are sent one at a
So the FPD-Link parallel pairs are carrying serialized data, but use a parallel clock to recover and synchronize the data. Serial data communications can also embed the clock within the serial data stream. This eliminates the need for a parallel clock to synchronize the data. There are multiple methods for embedding a clock into a data stream.