Ads
related to: 20 moa scope mount explained
Search results
Results from the WOW.Com Content Network
Scope mounts are rigid implements used to attach (typically) a telescopic sight or other types of optical sights onto a firearm. The mount can be made integral to the scope body (such as the Zeiss rail) or, more commonly, an external fitting that clamp onto the scope tube via screw-tightened rings (similar to pipe shoes). The scope and mount ...
Red dots for rifles typically have a smaller dot, often 0.6 to 0.8 mrad (2 to 3 MOA). When red dot sights started to appear at the practical shooting competition circuit in the 1990s, reticle sizes of up to 3, 4.5 or even 6 mrad (10, 15 or 20 MOA) were common in order to compensate for the lack of bright illumination. However, as red dot ...
The scope body is sealed and filled with nitrogen, which prevents fogging of optics and was designed to function within a -50 °C to 50 °C temperature range. For zeroing the telescopic sight the reticle can be adjusted by manipulating the elevation and windage turrets in 5 centimetres (2.0 in) at 100 metres (109 yd) (0.5 mil or 1.72 MOA ...
The scope base is the attachment interface on the rifle's receiver, onto which the scope rings or scope mount are fixed. Early telescopic sights almost all have the rings that are fastened directly into tapped screw holes on the receiver, hence having no additional scope base other than the receiver top itself.
A 5 moa (1.5 milliradian) dot is small enough not to obscure most targets, and large enough to quickly acquire a proper "sight picture". For many types of action shooting , a larger dot has traditionally been preferred; 7, 10, 15 or even 20 moa (2, 3, 4.5 or 6 mil) have been used; often these will be combined with horizontal and/or vertical ...
For this purpose scope mounts are sold with varying degrees of tilt, but some common values are: 3 mrad, which equals 3 m at 1000 m (or 0.3 m at 100 m) 6 mrad, which equals 6 m at 1000 m (or 0.6 m at 100 m) 9 mrad, which equals 9 m at 1000 m (or 0.9 m at 100 m) With a tilted mount the maximum usable scope elevation can be found by:
It is similar in concept to the earlier commercial Weaver rail mount used to mount telescopic sights, but is taller and has wider slots at regular intervals along the entire length. The MIL-STD-1913 locking slot width is 0.206 in (5.23 mm). The spacing of slot centres is 0.394 in (10.01 mm) and the slot depth is 0.118 in (3.00 mm). [8]
A Zeiss rail system typically adds height to the scope body, but also gives the possibility for a slimmer scope mount so that the total scope height can become comparable to a traditional ring mount. The added scope body height due to the rail piece on the scope itself contributes about 5.5 mm (0.22 in) to the total height.
Ads
related to: 20 moa scope mount explained