Search results
Results from the WOW.Com Content Network
Camless valve trains have long been investigated by several companies, including Renault, BMW, Fiat, Valeo, General Motors, Ricardo, Lotus Engineering who developed electro-hydraulic valve actuation in the late 1980s as a spinoff of their active suspension program (both utilised similar electro-hydraulic actuation and control), Ford, Jiangsu Gongda Power Technologies, and Koenigsegg's sister ...
The controlled part of the injector is a solenoid-operated spill valve. Normally, it is open, allowing the fuel to return to the supply line when the pump plunger descends. When the solenoid is energized, the spill valve closes, and the fuel is forced through the spray tip into the cylinder. The four phases of EUI operation are: Fill phase
Without power, the plunger extends for part of its length outside the coil; applying power pulls the plunger into the coil. Electromagnets with fixed cores are not considered solenoids. In simple terms, a solenoid converts electrical energy into mechanical work. Typically, it has a multiturn coil of magnet wire surrounded by a frame, which is ...
Vapor lock is a problem caused by liquid fuel changing state to vapor while still in the fuel delivery system of gasoline-fueled internal combustion engines.This disrupts the operation of the fuel pump, causing loss of feed pressure to the carburetor or fuel injection system, resulting in transient loss of power or complete stalling.
The magnetic field inside an infinitely long solenoid is homogeneous and its strength neither depends on the distance from the axis nor on the solenoid's cross-sectional area. This is a derivation of the magnetic flux density around a solenoid that is long enough so that fringe effects can be ignored.
The F20C was designed with high engine speed capability in mind, for increased power output; the rev limit is 9,000 rpm, with VTEC engagement at 6,000 rpm. Its relatively long stroke of 84 mm results in a mean piston speed of 4,965 ft/m, or 25.2 m/s, which was higher than any other production car to date. [ 4 ]
Partial stroke testing (or PST) is a technique used in a control system to allow the user to test a percentage of the possible failure modes of a shut down valve without the need to physically close the valve. PST is used to assist in determining that the safety function will operate on demand.
The long stroke also meant that piston speeds and the load on the big end bearings became potentially damaging at high power outputs. Many smaller British cars did not cope well with sustained cruising at 60 mph (97 km/h) or more, which led to reliability problems when the vehicles were exported to other markets, especially the United States.