Search results
Results from the WOW.Com Content Network
The frequency response for a conventional LP player might be 20 Hz to 20 kHz, ±3 dB. The low-frequency response of vinyl records is restricted by rumble noise (described above), as well as the physical and electrical characteristics of the entire pickup arm and transducer assembly. The high-frequency response of vinyl depends on the cartridge.
HF's position in the electromagnetic spectrum.. High frequency (HF) is the ITU designation [1] for the band of radio waves with frequency between 3 and 30 megahertz (MHz). It is also known as the decameter band or decameter wave as its wavelengths range from one to ten decameters (ten to one hundred meters).
High frequency [18] VHF: 0.03 to 0.3 GHz: Very high frequency [18] UHF: 0.3 to 1 GHz: Ultra-high frequency [18] L: 1 to 2 GHz: Long wave S: 2 to 4 GHz: Short wave C: 4 to 8 GHz: Compromise between S and X X: 8 to 12 GHz: Used in World War II for fire control, X for cross (as in crosshair). Exotic. [19] K u: 12 to 18 GHz: Kurz-under K: 18 to 27 ...
An audio frequency or audible frequency (AF) is a periodic vibration whose frequency is audible to the average human. The SI unit of frequency is the hertz (Hz). It is the property of sound that most determines pitch. [1] The generally accepted standard hearing range for humans is 20 to 20,000 Hz.
The higher frequency sound waves have a shorter wavelength and thus don't spread out as rapidly. For this reason, the resulting directivity of these devices is far higher than physically possible with any loudspeaker system. However, they are reported to have limited low-frequency reproduction abilities. See sound from ultrasound for more ...
Violet noise is also called purple noise. Violet noise's power density increases 6.02 dB per octave with increasing frequency [8] [9] "The spectral analysis shows that GPS acceleration errors seem to be violet noise processes. They are dominated by high-frequency noise." (density proportional to f 2) over a finite frequency range.
AC bias is the addition of an inaudible high-frequency signal (generally from 40 to 150 kHz) to the audio signal. Most contemporary tape recorders use AC bias. When recording, magnetic tape has a nonlinear response as determined by its coercivity. Without bias, this response results in poor performance, especially at low signal levels.
This transition frequency is popularly known as the Schroeder frequency, or the cross-over frequency, and it differentiates the low frequencies which create standing waves within small rooms from the mid and high frequencies. [3] The third region which extends approximately 2 octaves is a transition to the fourth zone.