Search results
Results from the WOW.Com Content Network
RFinder's main service is the World Wide Repeater Directory (WWRD), which is a directory of amateur radio repeaters. RFinder is the official repeater directory of several amateur radio associations. RFinder has listings for several amateur radio modes , including FM , D-STAR , DMR , and ATV .
A radio repeater is a combination of a radio receiver and a radio transmitter that receives a signal and retransmits it, so that two-way radio signals can cover longer distances. A repeater sited at a high elevation can allow two mobile stations, otherwise out of line-of-sight propagation range of each other, to communicate. [1]
Repeater frequency sets are known as "repeater pairs", and in the ham radio community most follow ad hoc standards for the difference between the two frequencies, commonly called the offset. In the USA two-meter band, the standard offset is 600 kHz (0.6 MHz), but sometimes unusual offsets, referred to as oddball splits, are used. The actual ...
An extensive digital repeater, or "digipeater" network provides transport for APRS packets on these frequencies. Internet gateway stations (IGates) connect the on-air APRS network to the APRS Internet System (APRS-IS), which serves as a worldwide, high-bandwidth backbone for APRS data. Stations can tap into this stream directly, and a number of ...
M17 uses Frequency-Division Multiple Access (FDMA) technology in which different communication streams are separated by frequency and run concurrently. It utilizes 4,800 symbols per second, 4-level frequency-shift keying (4FSK) with a root Nyquist filter applied to the bitstream. Radio channels are 9 kHz wide, with channel spacing of 12.5 kHz.
Monitor mode only applies to wireless networks, while promiscuous mode can be used on both wired and wireless networks. Monitor mode is one of the eight modes that 802.11 wireless adapter can operate in: Master (acting as an access point), Managed (client, also known as station), Ad hoc, Repeater, Mesh, Wi-Fi Direct, TDLS and Monitor mode.
The difference between the two frequencies may be relatively small compared to the frequency of operation, say 1%. Often the repeater station will use the same antenna for transmission and reception; highly selective filters called "duplexers" separate the faint incoming received signal from the billions of times more powerful outbound ...
The frequencies from 430 to 440 MHz are allocated on a secondary basis to licensed radio amateurs who are allowed to use up to 40 W (16 dBW) between 430 and 432 MHz and 400 W (26 dBW) between 432 and 440 MHz. Channels 1 to 14 are UK amateur repeater outputs and channels 62 to 69 are UK amateur repeater inputs.