Search results
Results from the WOW.Com Content Network
A lathe faceplate is a basic workholding accessory for a wood or metal turning lathe. It is a circular metal (usually cast iron) plate which fixes to the end of the lathe spindle. The workpiece is then clamped to the faceplate, typically using t-slot nuts in slots in the faceplate, or less commonly threaded holes in the faceplate itself.
A lathe dog is a mechanical device typically made of cast iron, steel or aluminum that transmits rotary motion from a faceplate to a workpiece mounted between centers in a lathe. [1] The tail of the dog is rotated by a slot in a driving faceplate, a stud mounted on a faceplate, or sometimes a side of a chuck jaw.
A backplate with threads may screw onto a threaded spindle nose (for lathe work) or onto an adapter plate with the same nose, to be mounted on the table of milling machines or surface grinding machines. This "threaded spindle nose" type of mounting was the typical method in the 19th century through 1930s.
The small plate shown in the first picture is a hand lapping plate. That particular plate is made of cast iron. In use, a slurry of emery powder would be spread on the plate and the workpiece simply rubbed against the plate, usually in a "figure-eight" pattern. Small lapping machine. The second picture is of a commercially available lapping ...
An angle plate is a work holding device used as a fixture in metalworking. Angle plates are used to hold workpieces square to the table during marking out operations. Adjustable angle plates are also available for workpieces that need to be inclined, usually towards a milling cutter .
A horizontal CNC gear hobbing machine Gear hobbing a spur gear to module 17dp on CNC cutting machine. Hobbing is a method by which a hob is used to cut teeth into a blank. We gear hobbing with a master hob or index hob on CNC gear hobbing machines who cut, gears, wheels, pinions, shafts and worms.
The fixed plate is shown in gold and six shafts each take a reciprocating motion from points on the gold plate. The shafts might be connected to pistons in cylinders. Note the power may be coming from the shaft to drive the pistons as in a pump, or from the pistons to drive the shaft rotation as in an engine
Dead center (the conical piece) mounted in the spindle of a lathe and being used to support a workpiece being driven by a carrier setup. A lathe center, often shortened to center, is a tool that has been ground to a point to accurately position a workpiece on an axis. They usually have an included angle of 60°, but in heavy machining ...