Search results
Results from the WOW.Com Content Network
A basic wheelie is the lifting of the front of the motorcycle off the ground by means of either power or use of clutching. There are many variations of the basic wheelie... Power wheelies – This wheelie can be done by either accelerating rapidly in a low gear, or by reaching the power band and then chopping the throttle.
A motorcycle fork is the portion of a motorcycle that holds the front wheel and allows one to steer. For handling, the front fork is the most critical part of a motorcycle. The combination of rake and trail determines how stable the motorcycle is. The 'fork' on a motorcycle consists of multiple components.
An automotive wiring diagram, showing useful information such as crimp connection locations and wire colors. These details may not be so easily found on a more schematic drawing. A wiring diagram is a simplified conventional pictorial representation of an electrical circuit. It shows the components of the circuit as simplified shapes, and the ...
The main area of controversy among engine break-in instructions is whether to run the engine slowly or quickly to initiate the process. Those who promote raising the power settings steadily will recommend changing the engine setting from low to high powers as to not work the engine too hard and create excessive wear on the cylinder wall (which ...
Motorcycle wheelie Wheelie at a tractor pull Wheelie at a drag race Manual on a BMX bike. A wheelie, or wheelstand, [1] is a vehicle maneuver in vehicle acrobatics in which the front wheel or wheels come off the ground due to sufficient torque being applied to the rear wheel or wheels, [2] or rider motion relative to the vehicle.
[5] [6] One other way that a bike can be balanced, with or without locked steering, is by applying appropriate torques between the bike and rider similar to the way a gymnast can swing up from hanging straight down on uneven parallel bars, a person can start swinging on a swing from rest by pumping their legs, or a double inverted pendulum can ...
The first flat-twin motorcycle engine was built in 1905 by the Light Motors Company in the United Kingdom. Originally named the Fée (renamed "Fairy" soon after its introduction), [15] it was designed as a "bicycle engine system" which transmitted power to a pulley on the rear wheel via a chain. [16]
Shaft-jacking can be minimised by devices such as parallelogram swingarms. A practical way to minimise squat on a chain-drive bike is to locate the final drive sprocket as close as possible to the axis of the swingarm pivot; the ideal solution is to make the final drive sprocket and the swingarm pivot concentric, as was done on the Hesketh V1000.