Search results
Results from the WOW.Com Content Network
A laser cut plywood box with two living hinges. A variant on the kerf bend can be used to create living hinges in laser cut wood. The technique is popular for making light-duty hinges with large radii. [7] It is also possible to create a living wood joint by hand, but the result is less accurate. [8]
An ornate brass door hinge A barrel hinge. A hinge is a mechanical bearing that connects two solid objects, typically allowing only a limited angle of rotation between them. Two objects connected by an ideal hinge rotate relative to each other about a fixed axis of rotation, with all other translations or rotations prevented; thus a hinge has one degree of freedom.
Air transfer fire dampers for doors are designed and tested for use in the lower part of door leaves and cannot be installed elsewhere or higher. In Europe, the fire door test EN 14600 and EN 1634-1 applies. Air transfer fire dampers in facades are vents applied in wall, eave soffit, gable or foundation. In the US, these are used to protect ...
A sliding glass door, sometimes called an Arcadia door or patio door, is a door made of glass that slides open and sometimes has a screen (a removable metal mesh that covers the door). Australian doors are a pair of plywood swinging doors often found in Australian public houses.
Panels are made slightly smaller than the available space within the frame to provide room for movement. Wood will expand and contract across the grain, and a wide panel made of solid wood could change width by a half of an inch, warping the door frame. By allowing the wood panel to float, it can expand and contract without damaging the door.
Metal connector plates. A truss connector plate, or gang plate, is a kind of tie. Truss plates are light gauge metal plates used to connect prefabricated light frame wood trusses. They are produced by punching light gauge galvanized steel to create teeth on one side. The teeth are embedded in and hold the wooden frame components to the plate ...
A pellet smoker is a temperature controlled smoker that burns wood pellets made of dried-out sawdust, about an inch long and 1/4 inch wide. The wood pellets are stored in a gravity-fed hopper that feeds into a motor-controlled auger by the temperature regulator. This auger pushes the pellets into the fire pot.
The bowls of tobacco pipes are commonly made of briar wood, meerschaum, corncob, pear-wood, rose-wood or clay. Less common materials include other dense-grained woods such as cherry, olive, maple, mesquite, oak, and bog-wood. Minerals such as catlinite and soapstone have also been used. Pipe bowls are sometimes decorated by carving, and moulded ...