Search results
Results from the WOW.Com Content Network
Sump pumps are used where basement flooding may otherwise happen, and to solve dampness where the water table is near or above the foundation of a structure. Sump pumps send water away from a location to any place where it is no longer problematic, such as a municipal storm drain, a dry well, or simply an open-air site downhill from the building (sometimes called "pumping to daylight").
The dry-sump system requires at least two pumps - one pressure and one scavenge - and sometimes as many as four or five scavenge pumps are used to minimize the amount of oil in the engine. The pressure pump and scavenge pumps are frequently mounted on a common crankshaft, so that a single pulley at the front of the system can run as many pumps ...
Recently completed infiltration basin for stormwater collection. An infiltration basin (or recharge basin) is a form of engineered sump [1] or percolation pond [2] that is used to manage stormwater runoff, prevent flooding and downstream erosion, and improve water quality in an adjacent river, stream, lake or bay.
Each pump is about 54.7 feet (16.7 m) high and 20 feet (6.1 m) in diameter, and together they can pump 3.1 million gallons (11,735 cubic meters) per minute. [ 5 ] Gauges inside the pumping station measure the water level inside and outside the barrier, and control the pumps, in order to maintain the water levels on either side as closely as ...
In most production automobiles and motorcycles, which use a wet sump system, the oil is collected in a 3 to 10 litres (0.66 to 2.20 imp gal; 0.79 to 2.64 US gal) capacity pan at the base of the engine, known as the sump or oil pan, where it is pumped back up to the bearings by the internal oil pump. A wet sump offers the advantage of a simple ...
Storm drain grate on a street in Warsaw, Poland Storm drain with its pipe visible beneath it due to construction work. A storm drain, storm sewer (United Kingdom, U.S. and Canada), highway drain, [1] surface water drain/sewer (United Kingdom), or stormwater drain (Australia and New Zealand) is infrastructure designed to drain excess rain and ground water from impervious surfaces such as paved ...
A pulser pump makes use of water that flows through pipes and an air chamber from an upper reservoir to a lower reservoir. The intake is a trompe, which uses water flow to pump air to a separation chamber; air trapped in the chamber then drives an airlift pump. The top of the pipe that connects the upper reservoir to the air chamber is ...
Gear pumps [1] [2] trochoid pumps [3] and vane pumps [a] are all commonly used. Plunger pumps have been used in the past, but these are now only used rarely, for small engines . To avoid the need for priming , the pump is always mounted low-down, either submerged or around the level of the oil in the sump.