Search results
Results from the WOW.Com Content Network
A crowbar circuit is an electrical circuit used for preventing an overvoltage or surge condition of a power supply unit from damaging the circuits attached to the power supply. It operates by putting a short circuit or low resistance path across the voltage output (V o ), like dropping a crowbar across the output terminals of the power supply.
This problem arises from small differences in the individual responsitivity of the sensor array (including any local postamplification stages) that might be caused by variations in the pixel size, material or interference with the local circuitry. It might be affected by changes in the environment like different temperatures, exposure times, etc.
CMOS inverter (a NOT logic gate). Complementary metal–oxide–semiconductor (CMOS, pronounced "sea-moss ", / s iː m ɑː s /, /-ɒ s /) is a type of metal–oxide–semiconductor field-effect transistor (MOSFET) fabrication process that uses complementary and symmetrical pairs of p-type and n-type MOSFETs for logic functions. [1]
A micrograph of the corner of the photosensor array of a webcam digital camera Image sensor (upper left) on the motherboard of a Nikon Coolpix L2 6 MP. The two main types of digital image sensors are the charge-coupled device (CCD) and the active-pixel sensor (CMOS sensor), fabricated in complementary MOS (CMOS) or N-type MOS (NMOS or Live MOS) technologies.
When the pixel wells are at near capacity, the photons themselves that have been exposed to the image sensor, generate enough energy to excite the emission of electrons in the image sensor and generate sufficient voltage at the image sensor output, [20] equating to a lack of need for ISO gain (higher ISO above the base setting of the camera ...
This is because CMOS may experience a failure mode known as a stuck-open fault, which cannot be reliably detected with one test vector and requires that two vectors be applied sequentially. The model also fails to detect bridging faults between adjacent signal lines, occurring in pins that drive bus connections and array structures.
An inrush current limiter is a device or devices combination used to limit inrush current. Passive resistive components such as resistors (with power dissipation drawback), or negative temperature coefficient (NTC) thermistors are simple options while the positive one (PTC) is used to limit max current afterward as the circuit has been operating (with cool-down time drawback on both).
A photograph taken with a damaged image sensor. Similar defects can also occur in charge-coupled device (CCD) and CMOS image sensors in digital cameras. In these devices, defective pixels fail to sense light levels correctly, whereas defective pixels in LCDs fail to reproduce light levels correctly.